F5F Stay Refreshed Hardware Desktop System powers off after 30 to 60 seconds of inactivity.

System powers off after 30 to 60 seconds of inactivity.

System powers off after 30 to 60 seconds of inactivity.

P
pappabajskorv
Junior Member
45
03-19-2020, 12:33 AM
#1
Hello everyone, my system powers off after about 30 to 60 seconds. It seems to crash right after I enter the password and switch to the desktop. Last time I changed my case, but no hardware components were affected. I've tested my 3 RAM sticks in various slots and even with dual, but the mainboard only has a 24-pin power connector from the PSU, an 8-pin CPU fan connector, and a graka interface with a 5600X Ryzen B550 Wi-Fi, Gtx 1070, and Corsair RAM. The power supply is from Corsair with a 450W rating. Earlier this morning, everything worked perfectly before I switched it on.
P
pappabajskorv
03-19-2020, 12:33 AM #1

Hello everyone, my system powers off after about 30 to 60 seconds. It seems to crash right after I enter the password and switch to the desktop. Last time I changed my case, but no hardware components were affected. I've tested my 3 RAM sticks in various slots and even with dual, but the mainboard only has a 24-pin power connector from the PSU, an 8-pin CPU fan connector, and a graka interface with a 5600X Ryzen B550 Wi-Fi, Gtx 1070, and Corsair RAM. The power supply is from Corsair with a 450W rating. Earlier this morning, everything worked perfectly before I switched it on.

X
54
03-19-2020, 09:07 AM
#2
It seems you're referring to the time it takes for the system to heat up. Make sure your CPU cooling setup is correctly connected.
X
Xavi_the_man10
03-19-2020, 09:07 AM #2

It seems you're referring to the time it takes for the system to heat up. Make sure your CPU cooling setup is correctly connected.

P
Pipper1222
Member
187
03-21-2020, 07:37 AM
#3
Already completed several times. It refers only to the 24-pin and 8-pin connectors for the CPU and fan from the CPU.
P
Pipper1222
03-21-2020, 07:37 AM #3

Already completed several times. It refers only to the 24-pin and 8-pin connectors for the CPU and fan from the CPU.

B
BoutorHD
Junior Member
27
03-21-2020, 11:48 AM
#4
What was the quality of the cold plate's contact area with the CPU? Did you remove the previous adhesive and apply a fresh layer when reinstalling it into the new enclosure?
B
BoutorHD
03-21-2020, 11:48 AM #4

What was the quality of the cold plate's contact area with the CPU? Did you remove the previous adhesive and apply a fresh layer when reinstalling it into the new enclosure?

Y
YohoZombie
Junior Member
10
03-21-2020, 04:08 PM
#5
I did not repaste it at all. I havent changed anything on the motherboard. Just Switched my case
Y
YohoZombie
03-21-2020, 04:08 PM #5

I did not repaste it at all. I havent changed anything on the motherboard. Just Switched my case

J
JEFF_JEFFERSON
Senior Member
627
03-22-2020, 11:37 AM
#6
ensure there are no connections causing power loss to your mainboard
J
JEFF_JEFFERSON
03-22-2020, 11:37 AM #6

ensure there are no connections causing power loss to your mainboard