System fails when CPU is boosted.
System fails when CPU is boosted.
I tried boosting my CPU, but it stopped working. After that, I swapped in a new CPU, which also failed. Then I replaced the GPU, but it didn’t work either. I reset the CMOS battery before any changes and double-checked all connections. Even after disconnecting and reconnecting everything, it still doesn’t function. I’m looking for advice on how to fix this.
Hello! I don't have details on your specific CPU model or the extent of overclocking you've done. Could you provide more information about the CPU you're referring to?
What specifications were used? I applied essentially all the OC adjustments in the BIOS. A CMOS reset should handle it.
CMOS reset is the method to restore functionality, but it must be carried out precisely following this sequence. Follow these actions in the correct order:
1: Disconnect the power supply from the unit or unplug the PC from the wall to remove all power (Important!), then press the power button several times to fully discharge the capacitors.
2: Remove the CMOS battery.
3: (Optional) Set the CMOS jumper to its "Clear" position if needed, though this is usually not necessary.
4: Wait 5-10 minutes, leaving the system in its current state.
5: After the waiting period, reset everything in reverse order—starting with step 3, then 2, and finally 1.
6: Once everything returns to normal, test the system. You’ll need to reset the BIOS settings, including time and date, as well as any other configurations. Be ready to do this at the original unit unless you’re certain it won’t affect performance.
7: If clearing settings proved difficult, consider an overnight reset—leave the jumper in "Clear" position for several hours (around 8 hours) before reversing steps 3 through 5.
Note: Some boards resist clearing; if this happens, plan for a longer overnight process and be prepared to adjust later.
Unless your voltage options reach 2.2v or higher, you won’t destroy a chip. Most high-end chips only survive around 1.8–2.1v, but I’ve seen the 2.1v setting on my p5q still works fine—though the actual voltage is only 2.05 because of voltage drop. I should check my UD3 since it can handle up to 2.3v.