F5F Stay Refreshed Hardware Desktop Slow performance on Ryzen 3600 with X370 Asus Strix

Slow performance on Ryzen 3600 with X370 Asus Strix

Slow performance on Ryzen 3600 with X370 Asus Strix

Pages (3): Previous 1 2 3 Next
C
cwalk133
Junior Member
2
12-08-2019, 12:32 PM
#11
System specifications:
CPU - Ryzen 5 3600 Mobo Asus Strix F x370
RAM - Kingston Hyper X fury 3200mhz
GPU - Asus Strix 1660ti
Power Supply - Coolermaster V750
Storage - NVMe Adata XPG 3200 HDD (4x2TB)
Case - Coolermaster CM590III
Cooler - Coolermaster MA410P (2 x 140mm Noctua Redux, 1500rpm)
Fans - 3 MSI 120mm Torx fans
Monitor - Acer XF240H
Cable management - Tidy cable solutions
C
cwalk133
12-08-2019, 12:32 PM #11

System specifications:
CPU - Ryzen 5 3600 Mobo Asus Strix F x370
RAM - Kingston Hyper X fury 3200mhz
GPU - Asus Strix 1660ti
Power Supply - Coolermaster V750
Storage - NVMe Adata XPG 3200 HDD (4x2TB)
Case - Coolermaster CM590III
Cooler - Coolermaster MA410P (2 x 140mm Noctua Redux, 1500rpm)
Fans - 3 MSI 120mm Torx fans
Monitor - Acer XF240H
Cable management - Tidy cable solutions

A
Ac1dicBlitzz
Member
206
12-10-2019, 02:38 AM
#12
In fact, it's not a boot loop but just slower performance. This issue mostly occurs with the third generation Ryzen processors.
A
Ac1dicBlitzz
12-10-2019, 02:38 AM #12

In fact, it's not a boot loop but just slower performance. This issue mostly occurs with the third generation Ryzen processors.

W
wifininja
Junior Member
4
12-10-2019, 03:17 AM
#13
W
wifininja
12-10-2019, 03:17 AM #13

D
DanielEmpire
Posting Freak
781
12-26-2019, 09:02 PM
#14
Not this one. The link points to a document from Kingston.
D
DanielEmpire
12-26-2019, 09:02 PM #14

Not this one. The link points to a document from Kingston.

6
661798
Junior Member
8
12-26-2019, 10:17 PM
#15
This isn't an RGB fan, that's for sure.
6
661798
12-26-2019, 10:17 PM #15

This isn't an RGB fan, that's for sure.

T
TheWornt
Junior Member
6
12-31-2019, 12:13 PM
#16
The RGB kit might have been a better choice based on the timing configurations. It's unclear if this memory will work on your system, so you can test it quickly. Set DOCP/XMP profile and disable Gear Down mode. Adjust the memory voltage to 1.35v, frequency to 2933mhz, then gradually increase to 3200mhz. If possible, try setting the SOC to 1.08v or 1.1v. Use HWInfo64 for temperature data and verify with CPU-Z.
T
TheWornt
12-31-2019, 12:13 PM #16

The RGB kit might have been a better choice based on the timing configurations. It's unclear if this memory will work on your system, so you can test it quickly. Set DOCP/XMP profile and disable Gear Down mode. Adjust the memory voltage to 1.35v, frequency to 2933mhz, then gradually increase to 3200mhz. If possible, try setting the SOC to 1.08v or 1.1v. Use HWInfo64 for temperature data and verify with CPU-Z.

A
AwsomeFace2
Member
202
01-01-2020, 02:39 AM
#17
my system is running at 1.1v with the new CPU, and it adjusts itself without any manual settings. I only changed the voltage because the room temperature here is quite high.
A
AwsomeFace2
01-01-2020, 02:39 AM #17

my system is running at 1.1v with the new CPU, and it adjusts itself without any manual settings. I only changed the voltage because the room temperature here is quite high.

M
MadzBlind
Junior Member
9
01-01-2020, 03:30 AM
#18
Typically, the system operates normally three times before entering safe mode. The memory chip is probably using the standard 2133MHz frequency. You can verify this by opening Cpu-Z after launching Windows via the "Memory" section.
M
MadzBlind
01-01-2020, 03:30 AM #18

Typically, the system operates normally three times before entering safe mode. The memory chip is probably using the standard 2133MHz frequency. You can verify this by opening Cpu-Z after launching Windows via the "Memory" section.

I
Infinity_PvPs
Member
205
01-03-2020, 10:47 AM
#19
I was running at 1500x before the upgrade. After the full setup, the PC fan started spinning for three seconds, then the CPU fan restarted and emitted a beep once back online.
I
Infinity_PvPs
01-03-2020, 10:47 AM #19

I was running at 1500x before the upgrade. After the full setup, the PC fan started spinning for three seconds, then the CPU fan restarted and emitted a beep once back online.

R
Royal_N
Junior Member
46
01-03-2020, 12:25 PM
#20
Memory speed is operating at 3200MHz via BIOS. 1600MHz at CPU Z due to dual channel configuration.
R
Royal_N
01-03-2020, 12:25 PM #20

Memory speed is operating at 3200MHz via BIOS. 1600MHz at CPU Z due to dual channel configuration.

Pages (3): Previous 1 2 3 Next