Shielding on Ethernet cables protects signals from interference and ensures reliable data transmission.
Shielding on Ethernet cables protects signals from interference and ensures reliable data transmission.
I changed my mind about this cable. It saves money compared to the other one, avoiding the extra tool and costly modular ends. Although it's pricier and doesn't have the braided sleeve around the foil pairs, it should be simpler to connect. What do you think I should choose?
Honestly, all the cables you've listed so far will do fine. Even standard UTP Cat6a isn't too susceptible to interference, unless you're really getting close to the 100m rated length for a single run. I have Cat6a running alongside 220-240v power cables and other ethernet cables running at 10G no problem. The braided sleeve really isn't needed, the foil on the pairs is good enough. Depending on how you're terminating it, you can do it basically without tools if you go for the more expensive keystone jacks (obviously the shielded ones as you're going that route). Other than that, it's standard IDC punchdown so shouldn't need to crimp anything. For cables from the wall sockets to any end points, I'd recommend just buying patch cables rather than messing about making your own. It's a pain and really don't save you any money, plus proper patch cables using stranded core are going to be more flexible and more resistant to bending than the solid core cable you're buying for in wall runs.
I completely agree! I just need it to be flawless so I never have to repeat the process again. This is exactly what I bought. There were several suggestions from professionals about using this cable. Although each pair isn't twisted, it still offers sufficient shielding for my needs and works with both PoE and PoE+. Thanks a lot!