Set up your router using a LAN cable for network connection.
Set up your router using a LAN cable for network connection.
I'm sorry, I don't understand much about this. I'm trying to explain how to link a router to an existing network inside a building. From one setup, some devices get internet while others don't, even though everything uses the same LAN cable. It seems like the router might not be working properly or maybe the access point needs to be turned on. I have two examples to show this problem, and in both cases, using just one device works fine, but with more devices it gets tricky. I tried a different router and got the same issue, so I'm not sure what went wrong. Thanks for your help.
I require every port from 1 to link with the router that has internet access. For the three devices, consider alternative configurations instead of purchasing a new router.
I'm trying to understand these details. The "existing network" seems overseen by a central router, but I need confirmation on whether port 1 is for LAN or WAN. Also, could you share the specific router model so I can give accurate information?
It's located in a sports gym with its own internet cables throughout the facility. I require it for streaming, as there aren't long cables available for cameras. My setup needs to be concentrated at one location, so I'm using a TP-LINK TL-MR6400 router with 802.11a/b/g/n, three LAN ports, WAN, two internal antennas, and a 4G LTE modem to cover all my devices. The device says port 1 is for LAN/WAN, but I haven't altered the default settings yet.
Do you control the gym and have access to the network gear behind all the cables? Could connecting a computer via an Ethernet port give you internet without your current setup? If yes, you don’t require a router—just a switch... Or at least change your MR6400 to AP mode if it supports it. Are you using the MR6400 with a 4G/LTE SIM card for mobile internet?
I don't have access to the gym. I'm streaming games for the local volleyball club, that's all. It should work fine, but I'm trying to save money and use what I have. I'll see how converting to AP point affects things. No problem because the gym has a strong internet connection.
In your current setup, it’s likely there are two NATs causing IP conflicts, probably because the gym already has a router in place. Plugging another router into that without proper setup will lead to issues. Here are general steps for configuring a TP-Link wireless router in AP mode. Remember, you’ll disable the DHCP server on the MR6400, so the gym’s router will handle IP assignment. Consult the network administrator to obtain a static LAN IP outside the DHCP range for the MR6400, which you’ll enter in the ‘IP Address’ field. Also, note the gym router’s IP for use as the ‘Default Gateway’. This approach reduces disconnections by keeping the MR6400’s IP stable until its lease ends. You can still use the LAN ports on the MR6400 for wired devices and set up wireless connectivity for mobile clients.