Set up network settings for accessing the NAS device.
Set up network settings for accessing the NAS device.
Hi everyone, I'm facing some issues with my PC setup. I have a shared folder connected to my main router, and from another PC (the main one), I created a shortcut pointing to the desktop folder. It worked fine initially. Now I’m connecting the main PC to a different Wi-Fi 6 router via Ethernet, and that router connects to my main router. However, I can’t access the shared folder. I’ve tried several methods—changing the shortcut’s IP, using internal or external IPs, even testing from another device on the main PC. It seems to bypass the Wi-Fi 6 setup somehow. I’m really trying to figure this out and would appreciate any help you can provide. Thanks!
I included an extra router because it’s leading to the problems you’re experiencing. Using just one router would resolve the issue.
Sorry, I need to clarify the reason before proceeding. I play VR, and for optimal performance it’s best to use WiFi 6 with no other devices on the router. A separate router is ideal. I’ve tested using another router, but between my PC and the wireless router there are two Ethernet switches, whereas with my dedicated router only one cable is needed. Given my setup and home layout, a dedicated router is the only practical choice. I also looked into swapping my Linksys router, but since I already have a Linksys mesh system, it would add unnecessary complexity or cost.
Your Wi-Fi plays a role in wireless VR because it affects connectivity stability. The headset connects via the LAN to the PC rather than directly, which can help avoid double NAT complications. Adding cables isn’t necessary since your current configuration already uses two cables. Low latency is key here, so wired networking is ideal. Consider setting up the Wi-Fi 6 router as an access point only, eliminating routing complexity and using a different SSID for clarity.
The problem isn't the cables but the switches affecting VR tracking. Because of how my system is configured, I can't lower the number of switches. The headset connects via LAN to the PC, not directly to it. This was true with my old Oculus/Meta Quest 2 and now with the Pico Neo 3 Link. The best solution might be switching to access point mode—let me check that option. Thanks.
Switches are now part of the “wired networking” setup in my case. They introduce minimal delay. Still, if you require Wi-Fi 6, you must configure the router to operate in AP, bridge, or DMZ mode, ensuring it functions as an access point rather than a router.
I understand you're experiencing some issues with VR connectivity, possibly due to interference from switches or other factors. I noticed you've been working on troubleshooting over the past couple of years, adjusting settings and testing different configurations. Recently, you received the Pico Neo 3 and started using it for sim racing, which helped isolate the problem. You tried connecting via wired mode with your PC and headset, but faced glitches when switching to wireless. After some research, you learned about setting your router as a direct access point, which resolved the issue and restored stable access to your NAS and PC. Now you're focusing on improving VR performance wirelessly. Your efforts are paying off—thank you for your patience and guidance!