Seeking feedback on battlefront presentation

Pages (2): Previous 1 2

155

03-13-2016, 08:24 AM

#11

Titan X SLI at 1080p with full scaling remains the native resolution. This can cause performance issues. Using 200% scaling, such as suggested by Geforce Experience, increases GPU demand.

GalacticattYT

03-13-2016, 08:24 AM #11

Titan X SLI at 1080p with full scaling remains the native resolution. This can cause performance issues. Using 200% scaling, such as suggested by Geforce Experience, increases GPU demand.

Hecchicero
Member

171

03-13-2016, 02:46 PM

#12

At 1080p with native settings, the FPS should rise compared to the lower frame rates at 150% or 200% scaling.

Hecchicero

03-13-2016, 02:46 PM #12

At 1080p with native settings, the FPS should rise compared to the lower frame rates at 150% or 200% scaling.

cabub3
Junior Member

03-18-2016, 01:15 AM

#13

You've adjusted the scaling settings and TAA is active, but the frame rate remains consistent with TAA enabled. This suggests the issue might be related to your Battlefield SLi profile rather than a general driver problem.

cabub3

03-18-2016, 01:15 AM #13

Thayys
Member

03-18-2016, 04:25 AM

#14

I believe sli profel works well in Battlefront since most people don’t complain about it... It might be a driver problem or there could be other reasons.

Thayys

03-18-2016, 04:25 AM #14

I believe sli profel works well in Battlefront since most people don’t complain about it... It might be a driver problem or there could be other reasons.

DuiveltjeX
Junior Member

03-19-2016, 09:49 PM

#15

60-70 FPS remains quite modest, particularly if your frame rate stays under 70. Have you tried different titles? Does your graphics card become slower when you boost the resolution to 200%? That’s not always the case. Two extremely capable cards struggle to reach their peak performance at such a low CPU-heavy setting.

DuiveltjeX

03-19-2016, 09:49 PM #15

westy801
Member

03-19-2016, 10:36 PM

#16

It looks like the problem is specific to SLi. With just one card, TAA works well but causes a noticeable drop in frame rate—plummeting to around 30 fps. I haven’t found any documentation confirming this behavior is standard or supported in SLi, so I’m leaning toward it not being reliable. It might be safer to stick with FXAA high instead. GPU utilization was 99% on GPU1 and over 70% on GPU2.