Searching for fiber ONTs that use Power over Ethernet.
Searching for fiber ONTs that use Power over Ethernet.
Seeking a solution for that high-speed symmetrical connection, it turns out fiber is more affordable than cable. The challenge lies in its recent installation and the limited reach of fiber to the outside junction box. Since the home is already CAT5-wired and landlords are hesitant about wall drilling, I need an ONT that fits in the box. Using the existing CAT5 for power and signal routing through a switch inside is an option. Would such a device be available, or would I need a low-power model with a POE splitter?
Most ONTs claiming PoE support act as outputs for other devices, not as inputs to power themselves. You’ll likely need a splitter and power injector. See the example setup (possibly AT&T-specific): https://andrewreaganm.com/powering-an-at...-ethernet/
I discovered a Ubiquiti product that supports PoE. https://www.ui.com/ufiber/ufiber-loco/ Others have shared experiences using the SFP directly into their Ubiquiti router or comparable equipment. I haven’t personally tried it yet. Ubiquiti mentions the signal must be below -8dBm from the OLT, which I assume applies similarly to Telus devices.
Interesting. Yes, Ubiquity produces quality products. I own some of their gear. It’s a shame they didn’t install an electrical outlet close to the exterior box or provide fiber access. You mentioned the house is CAT5 wired. Is it CAT5 or CAT5e? I believe the standard maximum for CAT5 is 100 Mbps, while CAT5e supports up to 1 Gbps. It would be a loss if you converted fiber to twisted pair, especially since bandwidth could drop significantly depending on the tier. Still, your setup would be reliable and if it’s more affordable than cable, why not?
I believe it's Cat5e. I'm confident I've achieved speeds over 100Mbps on a speedtest. I plan to test a direct connection within the house to confirm.
The fiber ends in this case connect directly to a simple outlet. No additional gear was added outside.
The ISP cut the fiber at the outside unit but it isn’t receiving power. The landlord is refusing the technician’s access to complete the proper termination inside.
Existing Ethernet cabling is already installed because it serves as a ready-made connection point. It wasn’t left empty—it was likely connected to power sources or other equipment before. Using it to pull through fiber without drilling a new hole isn’t straightforward, as the existing setup may require careful handling or additional modifications.