Seal de CPU desdividida

F5F Stay Refreshed Hardware Desktop Seal de CPU desdividida

Pages (3): Previous 1 2 3

spiritrider551
Junior Member

11-27-2017, 07:39 PM

#21

2 years experience using very little silicon adhesive—just a single dot at each opposite corner. I believe reworking isn’t needed at all.

spiritrider551

11-27-2017, 07:39 PM #21

2 years experience using very little silicon adhesive—just a single dot at each opposite corner. I believe reworking isn’t needed at all.

Hennessi
Junior Member

11-27-2017, 08:16 PM

#22

I handle the edges carefully. I don’t feel like setting up the whole machine on its side for the CPU. The constant shifting of the IHS is annoying while I try to manage it.

Hennessi

11-27-2017, 08:16 PM #22

I handle the edges carefully. I don’t feel like setting up the whole machine on its side for the CPU. The constant shifting of the IHS is annoying while I try to manage it.

TheSlimyPie
Junior Member

11-28-2017, 01:40 AM

#23

Relaying might fix issues like poor contact with the cooler or block if necessary. I remember needing to replace it several times after a delid; the cooler wouldn’t sit properly on the die and eventually required finding the correct cooler/block for a delidded chip. In most situations, a full reseal isn’t essential—just securing the corners to keep the lid in place works well.

TheSlimyPie

11-28-2017, 01:40 AM #23

YoungSquire
Member

11-30-2017, 02:13 AM

#24

I've also noticed many using excessive adhesive, which ruins the goal of delidding, leaving a large gap between the IHS and die. So, probably best to think carefully.

YoungSquire

11-30-2017, 02:13 AM #24

I've also noticed many using excessive adhesive, which ruins the goal of delidding, leaving a large gap between the IHS and die. So, probably best to think carefully.

Pages (3): Previous 1 2 3