F5F Stay Refreshed Hardware Desktop Reposition temperatures

Reposition temperatures

Reposition temperatures

N
NarwhalGamings
Member
69
06-06-2022, 08:15 PM
#1
Hey everyone, the readings seem fine at 13600k with a 5.3 p, 4.2e, and 4.7ring. Running it at 1.18vcore for a 240aio r23 in a 6-7 minute loop at 180w looks good.
N
NarwhalGamings
06-06-2022, 08:15 PM #1

Hey everyone, the readings seem fine at 13600k with a 5.3 p, 4.2e, and 4.7ring. Running it at 1.18vcore for a 240aio r23 in a 6-7 minute loop at 180w looks good.

P
playstation43
Member
61
06-13-2022, 02:10 PM
#2
Uncertain about the amount of paste used? I created a large area in the center and four smaller dots at the corners.
P
playstation43
06-13-2022, 02:10 PM #2

Uncertain about the amount of paste used? I created a large area in the center and four smaller dots at the corners.

G
Giblux
Junior Member
39
06-13-2022, 03:42 PM
#3
The conditions are ideal. You're well within the TjMax range. Using "too much" paste isn't practical, but spreading it generously works fine. If you went too light, the temperatures would indicate it. Your readings look normal—just keep it as it is and have fun with your PC!
G
Giblux
06-13-2022, 03:42 PM #3

The conditions are ideal. You're well within the TjMax range. Using "too much" paste isn't practical, but spreading it generously works fine. If you went too light, the temperatures would indicate it. Your readings look normal—just keep it as it is and have fun with your PC!

X
xNoBeef
Member
133
06-14-2022, 12:14 AM
#4
Hey, you're right about that. Using too much tends to push it out. It feels a bit higher now compared to before, but maybe just because the texture changed a little with the new paste. No worries about the anxiety—old versions were harder, so timing was important.
X
xNoBeef
06-14-2022, 12:14 AM #4

Hey, you're right about that. Using too much tends to push it out. It feels a bit higher now compared to before, but maybe just because the texture changed a little with the new paste. No worries about the anxiety—old versions were harder, so timing was important.

B
brogzter
Member
82
06-20-2022, 09:20 AM
#5
Exactly, would just be pushed out the sides. Sure, different pastes can vary a few degrees. But you may also have mounted the cooler just a tiny bit different than last time, causing a degree or two to go up. No reason to have anxiety over your current temps though, they are fine
B
brogzter
06-20-2022, 09:20 AM #5

Exactly, would just be pushed out the sides. Sure, different pastes can vary a few degrees. But you may also have mounted the cooler just a tiny bit different than last time, causing a degree or two to go up. No reason to have anxiety over your current temps though, they are fine