Random crash in pt2 module
Random crash in pt2 module
The post continues here. I experienced another crash today. It was recommended to check the Event Viewer after the incident. I did so and discovered a "critical" error with Event ID 41, indicating the PC crash. I attached my Event Viewer crash log. I’m seeking advice on which part is responsible for the crashes or useful troubleshooting tips. Since I cleared the CMOS recently, removed one of my two RAM sticks, and plan to wait before replacing it, I expect a delay. I’ll respond in the comments, but it could take some time as I’m also preparing dinner. Thanks, Magnus. Crash.txt
Sorry for the delayed response. Take a quick look at the link provided: https://softwaretested.com/windows/how-t...indows-10/. You might want to inspect your Device Manager for outdated drivers and consider updating them. Intel graphics could also be contributing to the problem. Verify that Fast Boot is turned off and review any sleep settings you've adjusted. The Power Management section is a good place to start. For safety, keep things balanced rather than prioritizing power saving or performance. If you can share your PSU model and its age, I can give more specific advice—especially regarding power stability and potential BSOD causes.
Also sorry for the delayed response. I'll review what you mentioned. Regarding the PSU, the issue started with a tx650m, but I purchased an hx1500i for a new build (selling this unit to my cousin, so I'm still using that system until it's resolved) and it happened again with the hx1500i. I also made sure not to reuse any of the same cables for the PSU. Thanks for your feedback.