RAM performance is limited to its maximum speed.
RAM performance is limited to its maximum speed.
Hi, your G.Skil Trident Z has a 16GB single stick RAM with XMP support and a boosted speed of up to 3200 MHz. However, you're only seeing half of that, around 1600 MHz. To reach the full potential, you might need to verify the RAM configuration, ensure it's properly seated, or check for any BIOS settings that could be limiting the speed. If the issue persists, consider updating your BIOS or consulting the manufacturer's support resources.
It's DDR memory, so displaying a 1600 MHz in CPU-Z and HWInfo works because it gets doubled to 3200. However, Task Manager still shows the listed frequency incorrectly. You might want to check the BIOS settings for XMP support, though it seems to be active as expected.
The genuine speed of memory modules is actually lower than what is claimed. The stated figure is accurate, but the real speed of your modules is 1600 Mhz. DDR1 through DDR4 operate as "DUAL DATA RATE," sending information both before and after each tick, effectively doubling the data flow compared to previous RAM at the same frequency. When DDR1 was introduced, marketers emphasized a performance boost, convincing many that double the data transfer was possible. In truth, these modules run at half the advertised rate, making higher numbers seem more impressive.
Did you mean the RAM was working at 1600 MHz rather than 3200 MHz? I actually wanted it to run at 3200 MHz.
The advertised frequency figures on packaging and memory sticks are doubled values. They actually describe the MT/s rate—specifically, two transfers per Hz before the "tick" and one after, with each tick representing a portion of those cycles within 1600 MHz. This means each stick handles 3200 transfers, or 1600 million cycles, delivering 64 bits per transfer. In reality, the actual operating frequency is half of what's claimed, matching the capabilities of modern DDR memory modules. The CPU’s internal fabric supports up to about 1733–1800 MHz, which aligns well with typical RAM speeds around 1600 MHz, ensuring smooth synchronization. To achieve 3200 MT/s, you’d need DDR4-6400 modules and a compatible motherboard.