RAID0 is no longer starting after installing CLONEZILLA.
RAID0 is no longer starting after installing CLONEZILLA.
I possess a dual M.2 configuration and another SATA drive that loads on my laptop. It functions properly with the laptop, but can I restore my RAID0 array if I applied the repair before copying? The target drive fails to boot as well, resulting in error messages like "cannot access..." and ultimately preventing further operation. I suspect Linux tools interfered with the Windows installation. Is there a straightforward solution using a recovery disk, or would I need to boot into Linux and use GParted to undo the clonezilla "fixing"? I’m prepared to investigate thoroughly and follow recommended fixes until I understand the root cause.
I think the data might have been erased during the cloning process. If that’s the case, there’s usually a chance to fix it, though with a RAID setup and no boot, repairs are tough. A fresh Windows installation seems like the best way forward.
It's possible you're right. The Windows dots spin twice before stopping, gradually slowing down with brief interruptions, then returning to a steady pace for a second before halting completely. This happened after fixing my C:/ drive using Clonezilla and undoing the repair. I'm referring to the source drive issue and trying to restore it via GParted or Windows Recovery Media.
You're allowed. However, it wouldn't relate to resolving my problem.