Question Struggling with Despair The Ancient Times
Question Struggling with Despair The Ancient Times
Yes, using the flashback method avoids short-circuiting or removing the battery.
Begin by powering down the PC. Insert the USB drive with the correct file as specified by the manufacturer to flash the port, press the flashback button, and wait for the process to complete. Ensure the flashback LED turns off or indicates completion. Allow a few minutes; if uncertain, let it run for 10 minutes to ensure full execution, though it shouldn't take long—just to be cautious and avoid disrupting the flashing. Once finished, disconnect power and do not restart immediately. Instead, switch off the mains, unplug the device, press the power button, and let it sit for a while to allow extra hard 'flea' power drain. Bridge the CLR CMOS pins on the motherboard using a screwdriver or jumper if available (older boards were shipped in buckets now). This action short-circuits the connection between the CMOS battery and the CMOS module to stop power flow from the battery to the CMOS. For more aggressive handling, remove the CMOS battery—this may be difficult if the housing is tight—and wait further before proceeding. The goal is to fully drain any remaining power and clear residual CMOS data. After that, press the power button a few times more, then reinsert the CMOS battery and connect the mains. Restart the system. All steps are taken to remove any risk of corrupted BIOS files. Cleaning a drain or gutter with a leaf left behind won’t stop the flow and won’t block it, though it isn't a perfect solution.
Yes, generally this is what CMOS clear involves.
1. Shut down the system and remove the power cord.
2. Drain any remaining power by pressing the PC power button.
3. (Usually necessary) Take out the GPU to access the CMOS battery.
4. Remove the CMOS battery.
5. Touch and hold a flathead screwdriver on the pins for 10-20 seconds to clear CLRTC.
6. Reinsert the CMOS battery.
7. Put the GPU back in.
8. Restart the system.
After restarting, the user will see a different boot screen, prompting them to return to BIOS for reconfiguration. After that, boot into Windows and retest.
yes and if you use a jumper don't leave it on when you turn the pwr back on shouldn't break anything but if the clr cmos pins are 'shorted' there is no pwr to the cmos so no settings can be saved in the volatile memory part of it.
which would produce functional anomalies.
The gpu does indeed often obscure the cmos battery housing. Does on this mobo it's under the 1st pci-e slot.
Some mobo's also have a clr cmos button on the rear i/o panel. This one doesn't according to the
manual
. That I saw.