Problems with XMP settings on A320 motherboard and R5 1400 graphics card

F5F Stay Refreshed Hardware Desktop Problems with XMP settings on A320 motherboard and R5 1400 graphics card

102

07-28-2017, 11:36 AM

I'm facing some problems when trying to apply the XMP profile for my RAM. It's currently running at 2400MHz and is rated for 3000MHz. My CPU is an R5 1400 board, and I'm using a Gigabyte GA-A320M-S2H-V2 motherboard. I've noticed that on BIOS (F10), it works perfectly without any issues. However, when XMP is enabled, the system sometimes boots in loops or fails to start properly. I'm concerned about potential damage if I try higher speeds after a crash. Could you help clarify which BIOS settings are best for this setup?

ChristobalMC_

07-28-2017, 11:36 AM #1

mrtinte
Junior Member

07-28-2017, 03:08 PM

Adjust the soc to 1.15 and dram to 1.35, then proceed with 2666 using xmp/docp. If it works, try 2933 and then 3000.

mrtinte

07-28-2017, 03:08 PM #2

Adjust the soc to 1.15 and dram to 1.35, then proceed with 2666 using xmp/docp. If it works, try 2933 and then 3000.

BigCraike
Member

07-29-2017, 12:13 AM

You need to turn on profile 1 (2933) and adjust the frequency to 2666. I’m not sure about the details of SOC or its settings in your BIOS, but I’ll get back with you soon.

BigCraike

07-29-2017, 12:13 AM #3

You need to turn on profile 1 (2933) and adjust the frequency to 2666. I’m not sure about the details of SOC or its settings in your BIOS, but I’ll get back with you soon.

martino433
Member

08-10-2017, 10:48 AM

Enable xmp/docp, proceed to 2666, and continue increasing up to 3000.

martino433

08-10-2017, 10:48 AM #4

Enable xmp/docp, proceed to 2666, and continue increasing up to 3000.

berude2403
Member

08-19-2017, 04:40 AM

Check if any tests are needed between steps. 2666 appears stable without the boot loop issue.

berude2403

08-19-2017, 04:40 AM #5

Check if any tests are needed between steps. 2666 appears stable without the boot loop issue.

Crazy_Heaven
Posting Freak

811

08-21-2017, 03:02 AM

You could execute memtest and verify stability at each frequency.

Crazy_Heaven

08-21-2017, 03:02 AM #6

You could execute memtest and verify stability at each frequency.

Broflash
Senior Member

740

08-25-2017, 08:38 PM

increasing the frequency to 2800mhz triggered a bootcycle, which resolved the issue. I wasn’t sure how to set the SOC to a fixed value or how to reach it via BIOS. I haven’t run memtest yet, but I completed some prime95 tests and everything seems stable now.

Broflash

08-25-2017, 08:38 PM #7

Aunorine
Member

130

09-02-2017, 09:49 AM

When applying default settings and selecting XMP version 2993, the device operates smoothly without restarting. It might only require a brief warm-up period before full use.

Aunorine

09-02-2017, 09:49 AM #8

When applying default settings and selecting XMP version 2993, the device operates smoothly without restarting. It might only require a brief warm-up period before full use.