Problems with RX 7800XT Sapphire Nitro+ RGB lighting
Problems with RX 7800XT Sapphire Nitro+ RGB lighting
Hello, I see you're having trouble with your GPU after upgrading. It sounds like the RGB strips aren't responding even though you connected the cables properly. Have you tried using a different cable or port? Also, check if the motherboard supports the RGB ports and if the drivers are fully installed. You mentioned using Armory Crate and Icue—make sure they're compatible with your board. If nothing works, consider checking for any firmware updates or looking into DMA settings as a workaround. Let me know what you find!
Get the software and verify compatibility with your motherboard or GPU synchronization feature in the RGB section. I understand Powercolor does this, so it's possible Sapphire does as well.
Ensure your GPU is compatible with Aura Sync or ICUE—your Asus TUF 6800 XT works with Armoury Crate but not with MSI Mystic Light and Signal RGB. Most of your RGB gear fits both, which is disappointing.
The environment under 'Nitro Glow' involves a setup using a 3-pin ARGB header signal. This configuration is applied on your system via Gigabyte RGB Fusion. Conflicts between different RGB applications, such as Corsair iCUE and ASUS Armory Crate, can cause issues. It's unclear if running both simultaneously will trigger problems. External Source provides guidance based on this setup.
I experimented with various configurations and settings, including using the external source. However, Armoury Crate (and other RGB software) fail to recognize the card. I tested on a different RGB port on my MOBO, but no improvement occurred. Some users reported similar problems with cards like the 7900 XT or XTX. I've already contacted Sapphire Tech Support for further details and will keep you informed.
I experience the same problem too, which means I'm eager to hear your thoughts if you're comfortable sharing!
The issue is consistent with your RX 7800 XT. It's connected properly but still won't turn on.