F5F Stay Refreshed Hardware Desktop Problem with the new PC not launching.

Problem with the new PC not launching.

Problem with the new PC not launching.

Pages (2): Previous 1 2
N
numblegs26
Member
197
07-09-2019, 07:32 PM
#11
Hey everyone!
N
numblegs26
07-09-2019, 07:32 PM #11

Hey everyone!

C
CJ_Skeleton99
Junior Member
16
07-10-2019, 12:03 AM
#12
The RAM is installed in the two right slots.
C
CJ_Skeleton99
07-10-2019, 12:03 AM #12

The RAM is installed in the two right slots.

M
maxinger_2
Junior Member
14
07-10-2019, 01:12 AM
#13
Lets start over, what have you done so far? everything you have done and tried.
M
maxinger_2
07-10-2019, 01:12 AM #13

Lets start over, what have you done so far? everything you have done and tried.

D
DatDrop
Member
190
07-10-2019, 09:22 AM
#14
No, this device does not support dual channel.
D
DatDrop
07-10-2019, 09:22 AM #14

No, this device does not support dual channel.

D
DrMaD17
Member
159
07-10-2019, 09:50 AM
#15
I used botd rams on the fourth position (starting from the CPU) and they functioned properly. They didn’t work on the second slot—it wouldn’t display when I tried to place one there. So I moved them to the third and fourth slots, where they worked correctly and both appeared on the PC.
D
DrMaD17
07-10-2019, 09:50 AM #15

I used botd rams on the fourth position (starting from the CPU) and they functioned properly. They didn’t work on the second slot—it wouldn’t display when I tried to place one there. So I moved them to the third and fourth slots, where they worked correctly and both appeared on the PC.

I
IcyIcicle
Member
53
07-13-2019, 01:25 AM
#16
With just one RAM stick, I’d update the BIOS to the newest version, then power off the PC. Insert the RAM in DIMM_A2 and DIMM_B2 following the user manual instructions, reset the CMOS, and check if the post works. If not, we can remove any faulty BIOS entries.
I
IcyIcicle
07-13-2019, 01:25 AM #16

With just one RAM stick, I’d update the BIOS to the newest version, then power off the PC. Insert the RAM in DIMM_A2 and DIMM_B2 following the user manual instructions, reset the CMOS, and check if the post works. If not, we can remove any faulty BIOS entries.

Pages (2): Previous 1 2