Problem with the new configuration Issue encountered during the latest setup process.
Problem with the new configuration Issue encountered during the latest setup process.
Hello everyone. The configuration was set up exactly as shown in the manual for the RAM slots A2 to B2. However, the system would randomly crash on the BIOS screen when adjusting any settings. I tried booting from USB to install Windows and encountered a BSOD. After removing one stick of RAM from slot B2, everything worked properly in BIOS. I adjusted the DOCP setting, restarted, and it booted fine again. After that, I installed the second RAM stick into slot B2 and everything functioned correctly without crashes. When I ran 3DMark on a USB drive, it performed well. Is it typical for the system to behave this way without correct timing, or do you suspect an underlying issue with the setup? Thanks!
It's possible. I'd check the disk with memtest just to be sure.