Problem with removing the CPU cooler backplate
Problem with removing the CPU cooler backplate
I’m thinking about putting it aside for later when I feel like doing it. Right now it’s just something I need to keep in mind.
In the future, using a small hammer and gentle taps should work well. Hold the board carefully from underneath and give very light impacts—movement comes easier with vibration than force. Be sure not to miss the moment; once you see a few millimeters of movement, it will come out easily. Occasionally the backplate may stick. Using pliers on a corner where screws are attached and pulling straight away can help. Avoid prying, as it could harm the board.
the tool with a delid is tough to remove. the old compound works well with the pads that come with thermal grizzly liquid metal. be mindful of using a plastic instrument to scrape off the old silicone. apply just a tiny amount of liquid metal and rub it in (it takes time) for both the top of the CPU and the IHS, helping release tension so they bond correctly when reassembled. i used heat-resistant silicone from a car parts store; alternatives exist. liquid metal link: https://www.amazon.com/Thermal-Grizzly-C...ADU4WUGJ11 delid kit: https://www.amazon.com/der8auer-Delid-Di...147&sr=8-3
RTV is similar to duct tape. It repairs nearly anything requiring a seal.
You might want to use the alignment tool for accuracy, but you can also align it manually. There’s no special trick without a tool, though.
the tool includes an alignment template and clamp to press IHS and chip together until the silicon sets, keeping the clamp centered for even drying and straight alignment. you must press them together carefully so the chip connects properly with the IHS without causing damage. a straight connection is essential; any edges will reduce contact quality. this step isn't mandatory but greatly helps streamline the process.
I discovered a more affordable option but it doesn't work with the relay tool. For me, the $40 price is quite reasonable, especially since I'm in Cambodia. Could I avoid using a relay tool and instead rely on the motherboard socket to position the IHS and secure it?