Problem with new installation on Windows 11
Problem with new installation on Windows 11
Only a single drive was added. The model used was WD_black sn850x.
I don't know what memtest is, but I'm seeing several options when searching for it. There seems to be confusion about which version to use, especially with Ubuntu compatibility in mind.
If you set up POP, you might also try installing Steam and see if it improves stability.
I ran Minecraft vanilla straight from the installer using maximum settings (32 chunks, great graphics, smooth lighting, etc.). After roughly ten minutes of continuous play in a straight line, the game froze. I didn’t know how to end a task on Linux, so I powered off the computer and turned it back on. After another ten minutes, the whole system crashed. When it restarted, it displayed these error messages:
[ 0.723239] mce: [Hardware Error]: CPU 5: Machine Check: 0 Bank 5: baa0000000010150
[ 0.723248] mce: [Hardware Error]: TSC X MISC XXXXXXXXXXXXXXXXX SYND XXXXXXXX IPID XXXXXXXXXXXXX
[ 0.723239] mce: [Hardware Error]: PROCESSOR 2:a20f10 TIME 1723421150 SOCKET 0 APIC a microcode s20102b
Since then, the time the computer remained on before restarting has been decreasing steadily, always returning this same microcode at the end.
Is this a fresh problem involving components and Linux, or does it relate to the original issue that caused trouble on your Windows? And when you checked the codes again, did you try running memtest?
Updated test results show a failure during memtest86 at test 7, followed by multiple failures at tests 7 and 8. The initial address error from the first run was identified as B0416250. Subsequent runs revealed additional addresses: 278101E08, 27810AB98, 27810D520 for test 7; and 35BA06FAO, 35BA0DEA4, 35BA0E3E0, 35BA0FEF8, 35BA1011C, and 35BA10130 for test 8.