Please confirm whether you made any mistakes and how you think they occurred.
Please confirm whether you made any mistakes and how you think they occurred.
I understand, I didn’t mean to interrupt you before. This is my first time setting up a PC, and everything seemed fine until I noticed the GPU isn’t fitting into the case properly. The metal contacts don’t align correctly, making it hard to secure. I checked the available information, but nothing clearly indicates the problem. The case I’m using is a Master Cooler 520 mesh, and the GPU is a 3060ti Ventus 2x. It’s a bit surprising since I thought it should work, but I’m not sure if that’s the issue. Could someone more experienced confirm whether the card really won’t fit? Thanks for your help!
I can adjust the angle to capture a clearer view. The 3060ti ventus 2x will fit perfectly here without any problems.
The gap between the motherboard edge and the back end of the case needs adjustment. Place the two tabs in that space first, aligning them before positioning the GPU. Follow the pin alignment with the slot afterward. This setup was reviewed using a 3080 as described on KitGuru.
The slots on the bottom of the IO plate (the metal backing of the card) are slightly bent. You just need to gently straighten them a bit, and they should fit properly. Use pliers carefully for this.
Learn how to install a graphics card GPU on your PC from Beebom's guide.
It seems the GPU wasn't placed correctly. The issue appears to be that the case is too compact, causing blockage on the opposite front side. The gap between the PCIe slot and the rear remains consistent across all cards.
Avoid making changes to the tabs. These cards are designed for exact fit, and countless millions—possibly billions—have already been installed perfectly.
I revisited the issue and quickly realized my mistake. The fit was tighter than anticipated, which led me to believe the prongs should be on the outside because it didn’t seem to fit inside. Thanks to everyone for your prompt and courteous responses—no worries about forum rules! Now I’m unsure what to do next; should I close the thread or something? I’m not sure how forums operate, so I apologize ahead of time.