Performance concerns at high speed 5800x 3600MT/s
Performance concerns at high speed 5800x 3600MT/s
It should adjust automatically to what it requires. Leave all your RAM settings as they are. Don’t alter anything except set the XMP to 3200 to test. If it progresses smoothly to the next level, continue; otherwise, check the current speed. Modern systems can now handle this process efficiently.
Bro, it’s weird how few good settings people share anymore... Used to be pretty standard. With the 3000 series you usually have to tweak things yourself, like SOC and RAM voltage—especially with XMP. It’s been a while since I did that, or I just skip XMP to see if it works better. XMP is more about overclocking and isn’t always reliable.
It wasn't exactly what you expected... 2933 was the ideal balance for stability... Often required several weeks of tuning to reach 3600 stable... Later it seemed like 5000, but getting 3600 remained challenging... Still, most issues were related to RAM, not hardware... It's funny how many people thought this would be easy, but in reality, it was a bit trickier than with lower speeds. Back then, stability was much better with DDR2/DDR3 as I remember.
Verify the SOC level, my setup is at 1.112V... otherwise 3600 won't function... Also, RAM voltage is configured for 1.36 (it reads 1.35, but if set to 1.36 it would boot, otherwise wouldn't)
Clock didn't auto-sync perfectly but I can adjust it myself. I believe 3200mhz works well so far, though I haven't run a complete memory test yet. The automatic SOC voltage on this board seems too high—around VDDCR SOC 1.2V and 1.194V SVI2 TFN. It's been most stable at 3600mhz with SOC at 1.03V and DRAM at 1.36, but still not fully consistent. I think the VRM being limited under CPU load leads to instability when SOC rises higher.