pc stopped working during an overclock attempt and required a CMOS reset.
pc stopped working during an overclock attempt and required a CMOS reset.
Hi
These are the details of your components
MSI 760GMA p34(fx)
FX 6300 @ 4.2ghz
GTX 970 SSC
gskill 8gb 1600mhz cas 10
evga 500w 80 plus
I was trying to push my CPU further, so I increased the voltage to 1.425v and set the multiplier to 4.3ghz in BIOS. After saving and rebooting, the PC started but didn’t power on. I reset the CMOS by shorting the pins and eventually got it to turn on.
I’m wondering if I made a mistake. I didn’t change anything except the multiplier, VDD voltage, and a few other settings like CLK and QUART. Could you check if that’s the maximum the motherboard allows? Or is there another way to overclock safely? Also, would it help to adjust the CPU-NB VDD or the clock source? Please let me know.
BTW, I know my motherboard isn’t perfect either, but I’m willing to try and my friend managed to get his FX 8320 up to 4.2ghz @ 1.42 volts on this board.
Sameer25 replied to JamesSneed saying they didn't do anything wrong, just pushed it too far. Suggesting going back to 4.2Ghz and testing with less than 1.375 volts. The question is whether the CPU is a poor overclocker that has hit its limit.
It wasn't your fault. I moved it too far. Return to version 4.2Ghz, everything should work. I might test 4.2Hgz at under 1.375 volts.
What is your CPU's stock speed? It seems you've reached a limit, and I think increasing the voltage isn't ideal; I favor a modest boost instead. Also, does your MOBO support an LLC option? That would significantly reduce voltage drops. Please verify the overall chip voltage input, not just the core voltage.
What's your CPU's stock speed? It seems like you might be hitting a ceiling, and I think increasing the voltage isn't ideal—smaller jumps work better. Also, do you have an LLC option on your MOBO? That really helps with voltage drops. Make sure to check the total chip voltage input, not just the core voltage. My stock is 3.5.
JamesSneed is asking if the situation indicates his CPU is an overclocker that has hit its maximum capacity.
Sameer25:
Juannfox asked about your CPU's stock speed and whether changing the voltage too much is a good idea. They also inquired if your MOBO has an LLC option, which would help with voltage drops. Additionally, they mentioned checking the total chip voltage input, not just the core voltage.
My stock is 3.5, but it might be right on the limit. I’d prefer to stay at 4.2 with the lowest possible voltage to avoid extra heat.
Sameer25:
JamesSneed:
No, you didn't do anything wrong. I just pushed it too far. Go back to 4.2Ghz and everything should be okay. I might try 4.2Hgz with less than 1.375 volts.
Does that mean my CPU is a bad overclocker and has hit its limit?
It seems like that.
JamesSneed responded to the situation, suggesting it might be a matter of pushing the CPU beyond its limits. He advised returning to a lower frequency like 4.2Ghz and considered adjusting voltage settings. The conversation also touched on whether the CPU is a poor overclocker or if further attempts at higher frequencies are feasible.