PC activates and then shuts down after a short delay.

Pages (2): 1 2 Next

6_alvaroYT_6
Junior Member

09-05-2017, 05:08 PM

I'm facing an issue with my PC. I've tried all troubleshooting steps, but the motherboard lights appear and everything works until I press power. The power supply seems fine, I've replaced the RAM, removed everything from the case, and tested without the GPU. It's still showing as an 8600k model with ASRock Z370 Extreme4 Corsair HX 1000, but it's not working. Anyone have any advice?

6_alvaroYT_6

09-05-2017, 05:08 PM #1

Just_Senya
Member

169

09-14-2017, 12:30 PM

Clear CMOS by removing one stick at a time

Just_Senya

09-14-2017, 12:30 PM #2

Clear CMOS by removing one stick at a time

cutcake
Junior Member

09-14-2017, 07:22 PM

Tried all options already.

cutcake

09-14-2017, 07:22 PM #3

Tried all options already.

Beccaa
Junior Member

09-14-2017, 08:16 PM

You're asking about the initial startup process. Does it send a signal, and are there any error codes or lights indicating problems during that phase?

Beccaa

09-14-2017, 08:16 PM #4

You're asking about the initial startup process. Does it send a signal, and are there any error codes or lights indicating problems during that phase?

DutchMenno
Member

09-15-2017, 01:41 AM

Board displays voltage and nothing else appears.

DutchMenno

09-15-2017, 01:41 AM #5

Board displays voltage and nothing else appears.

ErenKartal
Member

161

09-15-2017, 07:08 AM

Mobo lights are active yet the power switch remains inactive, causing no output on the screen. The fans spin without any signal, and the monitor fails to power up to the BIOS.

ErenKartal

09-15-2017, 07:08 AM #6

Mobo lights are active yet the power switch remains inactive, causing no output on the screen. The fans spin without any signal, and the monitor fails to power up to the BIOS.

Kronicftw
Member

195

09-15-2017, 09:22 AM

Do you hear any beeps? Is the PC speaker connected? Since there isn’t an error code shown, it looks like a similar issue was discussed in ASRock forums.

Kronicftw

09-15-2017, 09:22 AM #7

Do you hear any beeps? Is the PC speaker connected? Since there isn’t an error code shown, it looks like a similar issue was discussed in ASRock forums.

YoshiproMC54
Member

09-21-2017, 08:14 AM

It seems the CPU is likely the issue. Removing the 8-pin connector from the motherboard causes it to start without problems, but reinserting the CPU cable makes it turn on and off immediately.

YoshiproMC54

09-21-2017, 08:14 AM #8

It seems the CPU is likely the issue. Removing the 8-pin connector from the motherboard causes it to start without problems, but reinserting the CPU cable makes it turn on and off immediately.

kervinc
Posting Freak

804

09-21-2017, 10:13 AM

It could also be the PSU.

kervinc

09-21-2017, 10:13 AM #9

It could also be the PSU.

Chunks_Lds
Junior Member

09-21-2017, 11:51 AM

#10

I've tested another power source but the issue remains.

Chunks_Lds

09-21-2017, 11:51 AM #10

I've tested another power source but the issue remains.

Pages (2): 1 2 Next