Overheating issue with the I7-14700k processor.
Overheating issue with the I7-14700k processor.
Here are your details rephrased:
- CPU: i7-14700K
- GPU: MSI RTX 3070 (3 fans)
- Motherboard: MSI Z790 Gaming PRO WiFi
- RAM: CORSAIR 32GB DDR5 7200MHZ
- Power Supply: Corsair RM1000e (2023)
- PC Case: Corsair 275R Airflow Mid-Tower ATX
- Cooler: be quiet!
- Issue: Dark Rock 5 – temperatures spiked to 100°C during BO6/Rust gameplay, reaching 85-90+
- BIOS update: Applied latest release
- CPU overclocking: Tried adaptive + Offset mode with offsets -0.050 and 0.075; results varied
- Notes: No further updates needed unless you have other requests!
It seems the cooler should support 210W based on the BeQuiet! site. However, with a total package power draw of 228W, cooling it becomes a challenge. Let's eliminate simple mistakes first: have you taken off the plastic film from the cold plate? Did you spread enough thermal paste? Are the mounting kit screws tightened properly? Were they secured in a cross pattern? Was the cooler evenly attached to the mounting kit?
I've taken out the plastic wrap. I'm using CORSAIR XTM50 Thermal paste (purchased four years ago, kept in original packaging, no exposure to air) along with a spatula. At first I spread a thin layer evenly (possibly missed a corner), then pushed it slightly in the middle before putting the cooler on top. I tightened gently, stopping when resistance appeared to avoid damage. I can't make a cross pattern since only two screws are available on the sides. I thought about using a screwdriver—inserted it into one screw, placed it in the corresponding hole on the CPU, tightened briefly, then switched screws and adjusted again.
It seems you're checking if the cooler on the CPU moves properly and whether it twists when you try to adjust it. You might need more force to secure it. A good test is to run it at high temperatures and press down firmly—if the temperature drops, the screws likely weren’t tight enough.
Additionally, I overlooked that the temperature images were considered benchmarks for BO6. Even without using Windows and browsing, the heat stays near 40-50°C, dropping to about 38°C during idle when I'm not actively using it.
I reduced voltage on the 14600KF to 220W, with overclocking at 5-6Ghz. Arctic Freezer AIO water cooler still reaches about 90°C during OCCT SSE load for roughly ten minutes. The 14700K requires cooler water below 100°C.
Never used an AIO before and haven’t intended to buy one soon, just worried about damage or leaks inside the computer.
I was doubtful about AIOs for years. Now I own one for four years, it runs without leaks and the pump shows no signs of failing. AIOs don't really leak at all. However, in theory the "air-coolers" might last longer. In reality AIOs are now reliable.