Overclocking Problems at 5-2500K Temperature
Overclocking Problems at 5-2500K Temperature
Hi!
I'm having trouble with overclocking this computer. My I5-2500k CPU is running on a Gigabyte GA-Z77x-DH3 board. I only adjusted the base clock from 3.3 to 3.4ghz, but when the system starts it jumps to 6 to 7.1ghz. I'm not sure why this happens. The voltage stays at 1.23. I've also tried disabling Turbo mode without any effect. Since I don't have a water cooling system, overheating seems likely. Turning the base speed back to 3.3 makes it normal again.
So to be clear, you're only changing the multiplier, not the base clock, right? Never modify the base clock, just tweak the multiplier.
Reset the motherboard using a CMOS reset.
Use the battery method instead of the jumper method.
If the battery option is too challenging because it's in a hard-to-reach area, try the jumper method.
https://www.intel.com/content/www/us/en/...ssors.html
For further overclocking guidance, see this article: https://www.overclockers.com/forums/show...-to-4-5Ghz
Don't focus too much on aiming for 4.5Ghz; if you manage that, it's excellent, but otherwise stick to the guide to grasp the process...
So to be clear, you're just changing the multiplier, not modifying the base clock, right? Never alter the base clock, just focus on adjusting the multiplier.
Reset the motherboard using a CMOS reset procedure.
Use the battery method rather than the jumper method.
If accessing the battery is challenging due to its location, consider trying the jumper method.
Refer to the provided Intel support article for overclocking details.
Check the Overclockers forum thread for beginners' advice on reaching 25-6-700K at 4.5Ghz.
Don't prioritize achieving 4.5Ghz; if possible, it's fine, but stick to the guide for proper overclocking steps.
Avoid overclocking with a stock cooler or low-quality alternatives.
Ensure you have a suitable cooler capable of handling higher temperatures.
Updating the BIOS to the latest version is recommended only if you still face problems.
Yes, that's correct. It was the multiplier that caused the issue, not the base clock. I'll attempt to reset the CMOS now.