Only a single PCIe x16 port is available. Consider alternatives or check for additional slots.
Only a single PCIe x16 port is available. Consider alternatives or check for additional slots.
This product is an ADT 90-degree degree extension for the R11SL TL extender.
Here are some alternative versions of your text:
- PCI-E X1 to PCI-E X4 riser cables are available on eBay. These allow longer cards to fit in the X4 slot and provide separate power via a SATA connector, since USB only transmits data.
- Another model supports both power and data, with an X1 port that includes a cutout for wall mounting. You can insert X4, X8, or X16 cards, though some connectors may be loose at the end. The cable is flexible enough to avoid blocking fans.
- PCI-E X1 to X16 riser cables exist in various designs. Some have multiple power connectors—choose between Molex or a 6-pin PCI-E connector. The card slot remains straight, but you can use a different angle version for X16 if needed.
It's not a 90-degree bend—it's a straight adapter. When you check the linked example, you'll notice the end fitting into the PCIe slot is at a right angle. You'd need to confirm it doesn't get too close and cause issues with the GPU. Maybe some measurements are necessary.
Start with the first option. Insert the x16 card into the designated slot and leave part of the connector exposed. (If you're cautious, cover the unused edge connector on the card with a strip of paper bent in half—though I’d prefer not to mention electrical tape, as it could leave residue after removal.) You might also use a PCI-E x16 to x16 adapter like these examples: https://www.amazon.de/Easydiy-Express-16...0739Y2P4B/ or https://www.amazon.de/EZDIY-FAB-Extreme-...08S75V1Y6/. Then, use a sharp knife, razor blade, or hobby saw to trim the connector until only seven contacts remain after the notch—this matches the standard PCI-E x1 pinout. See https://pinouts.ru/Slots/pci_express_pinout.shtml or the accompanying diagram for guidance.
I purchased the riser (x1 to x1). The slot on the riser has an open end, so the card should fit naturally. I also acquired the card. If it functions correctly, we'll observe... I'll refresh the topic once the components arrive (this week). Edited September 28, 2021 by ValentinVV
The DVB-S2 card isn't compatible with the slot taken by the graphics card. The cable/adapter/riser I purchased doesn't work either. I won't continue discussing this issue, though I appreciate your help!
I expected a PCI-e card. The eBay ad lists a PCI standard card, which fits traditional PCI slots—before PCIe and AGP (reserved for graphics cards). It’s still usable; you can purchase PCI-e X1 to PCI adapters. However, I should note they aren’t fully confirmed compatible with every PCI device available. Here are some examples:
- https://www.ebay.de/itm/401925768834
- https://www.ebay.de/itm/253349895721
- https://www.amazon.com/PCI-Express-32bit...B00KZHDK4Q
These use an asMedia controller, which is a step up from the Pericom chips seen in other listings (recognizable by the large P logo). An adapter card that pairs well with LOW PROFILE PCI cards can be found here: https://www.amazon.com/StarTech-com-PCI-...B0024CV3SA.
Regular or standard cards tend to work less reliably in these slots. Near the two white PCI ports is a controller chip that acts as a bridge, allowing most PCI cards to function properly.
To invest more in this project, consider purchasing a used PC nearby that already has the required port. Additionally, the power cable connector on the card doesn't match your power supply.