Once the PC is cleaned, it still won’t start, and I need to fix it.
Once the PC is cleaned, it still won’t start, and I need to fix it.
You're dealing with a college student setup that needed some cleaning and component changes. The system was dusty, so you replaced the CPU cooler and thermal paste. You removed the GPU and RAM, then reassembled everything. When you powered it on, the RGB lights activated but the boot process showed several error codes. The no recognized CPU, GPU, and RAM LEDs were flashing. After loosening the cooler, the boot sequence now cycles through those lights before showing the boot drive failure and "no iGPU" warnings.
For your situation, here are some suggestions:
- Check if the RAM sticks are properly seated and not damaged.
- Ensure all connections are secure, especially the power and data cables.
- Verify that the CPU cooler is correctly installed and not obstructing fans.
- If the iGPU LEDs persist, try reseating the GPU or updating the BIOS/firmware.
- Consider using a different RAM type if compatibility issues arise.
- If the problem continues, consult the manufacturer's support or a tech forum for your specific model.
Let me know if you need help with any of these steps!
Replace the RAM and verify it clicks securely from both sides. Also inspect the cables, paying close attention to those above the CPU—your 24-pin should work, but give it a test. This is usually about identifying the initial mistake. It’s highly probable there’s something loose.