F5F Stay Refreshed Hardware Desktop OC for Ryzen 2400G: Assistance Required

OC for Ryzen 2400G: Assistance Required

OC for Ryzen 2400G: Assistance Required

R
RabbitKiller99
Member
140
04-10-2022, 03:09 PM
#1
Hello, your testing at 2400g to 3.9Ghz is interesting. The screenshots you shared might clarify things. In BIOS, the offset is set to -0.072, but it displays 1.368V in Easy mode while showing higher voltages in the system. Could this be due to calibration differences or firmware behavior? It’s important to verify the actual voltage values to ensure safety. Let me know if you need further guidance!
R
RabbitKiller99
04-10-2022, 03:09 PM #1

Hello, your testing at 2400g to 3.9Ghz is interesting. The screenshots you shared might clarify things. In BIOS, the offset is set to -0.072, but it displays 1.368V in Easy mode while showing higher voltages in the system. Could this be due to calibration differences or firmware behavior? It’s important to verify the actual voltage values to ensure safety. Let me know if you need further guidance!

D
DrCrazyBoy
Junior Member
17
04-12-2022, 03:18 PM
#2
Minus offsets reduce the voltage.
D
DrCrazyBoy
04-12-2022, 03:18 PM #2

Minus offsets reduce the voltage.

F
flurp1000
Junior Member
14
04-12-2022, 05:39 PM
#3
You're remembering correctly about the 2400g max. When you adjusted mine, you didn't change the offsets since you weren't familiar with them. You just reduced the CPU voltage. Currently it's around 1.31v at 3.8ghz across all cores. Do you have an option to lower the voltage?
F
flurp1000
04-12-2022, 05:39 PM #3

You're remembering correctly about the 2400g max. When you adjusted mine, you didn't change the offsets since you weren't familiar with them. You just reduced the CPU voltage. Currently it's around 1.31v at 3.8ghz across all cores. Do you have an option to lower the voltage?

M
Mc_cat_rules
Junior Member
47
04-19-2022, 04:28 PM
#4
I only have the offset information. I'll test it with -0.085 tomorrow to check for stability.
M
Mc_cat_rules
04-19-2022, 04:28 PM #4

I only have the offset information. I'll test it with -0.085 tomorrow to check for stability.