No visual display, red light positioned at the top right of the motherboard.
No visual display, red light positioned at the top right of the motherboard.
So i just finished building my 2nd pc in life. Connected it with DP 1.4a to AW2523HF and got no display at all. There is also a red light on top right of the motherboard. RGB of every component works. The first things that catched my eye was both of RAMS not clicking even tho i used a bit force to do it. Then at the end GPU Pcie 16x didn’t click too. In my opinion the cpu and gpu power cables are fine but i’m not sure. So far i’ve only tried turning it on/off and switching DP with HDMI
SPECS
9800x3d
5070ti msi gaming trio
X870E rev 1.1
Corsair Vengeance 6000 30 32
Corsair RM1000X
LFIII
H7 Flow RGB 2024
(Sorry for no photo but i have no idea on how to attach it, the red light is next to the LCD screen showing cpu temp i think)
The motherboard is a main component, its specific make and model need further details for identification.
Also, the small screen displays two digits, and during the red light phase what information appears there?
The guide for your motherboard.
https://download.gigabyte.com/FileL...12...18fb265b23
1, take out and reposition your GPU. Verify that the power connectors are correctly attached.
2. If possible, remove the CMOS battery, located at the bottom right near the CMOS reset header. Ensure no power is connected and the battery is disconnected to avoid a short circuit across the two pins.
Manual page 4
3 Make sure the memory is installed properly in slots A2 and B2.
Manual page 15
4 Confirm the CPU is seated correctly.
The debug display shows a fault when super IO and peripherals are about to be detected.
The LED indicates VGA.
Ensure all components are reassembled and attempt to restart. If it fails to power down, unplug the mains. Check if you have an HDMI display. If available, detach the GPU and connect a cable from the HDMI monitor to the HDMI port (refer to manual page 17, port D).
First and third steps are completed, but the VGA red light remains on. Preparing to proceed with the second step. I’m unsure when to reinsert the GPU, as I don’t feel confident. The PCIe clip seems to tighten again, but it’s a slow process and there’s no sound. In every PC build video I’ve watched, it clicked. The fourth step could be challenging since the entire build is finished now, but I’ll give it another try if nothing else works. How can I confirm the installation was done correctly? HDMI still doesn’t display anything, and neither does DP.