No interface appears during startup.

Lewky_
Member

12-11-2016, 09:22 PM

Hello, I just started assembling a new computer after moving houses. Here are the specifications: APU – Ryzen 3 3200G, Motherboard – Gigabyte GA-B450M-DS3H, RAM – Hyper X Fury 3200MHz DDR4 (1x8GB), Power Supply – Corsair CX450M. When I power on the system everything starts up, fans spin, motherboard LEDs illuminate, but no signal appears on the monitor. I’ve double-checked all connections: 8-pin APU, 24-pin M.2 slot, CPU fan, RAM placement, and cables. The case lacks a speaker, so I can’t hear any error sounds. I used an HDMI cable for the monitor and tried DVI with another monitor, but nothing worked. Any advice would be really helpful. Thanks.

Lewky_

12-11-2016, 09:22 PM #1

Kynedee
Posting Freak

784

12-13-2016, 04:26 AM

Have you experimented with RAM in another port? Shift it one position to the right, then continue until it reaches the end.

Kynedee

12-13-2016, 04:26 AM #2

Have you experimented with RAM in another port? Shift it one position to the right, then continue until it reaches the end.

Fufuit
Member

174

12-17-2016, 02:13 PM

I've checked all the slots.

Fufuit

12-17-2016, 02:13 PM #3

I've checked all the slots.

LapisCookieYT
Member

12-23-2016, 08:47 AM

Check if your motherboard shows issues or boot codes. The Ryzen 3000G processors require the latest BIOS to function properly and will not start without it. You’ll typically encounter a CPU-related error on the motherboard.

LapisCookieYT

12-23-2016, 08:47 AM #4

xKing_Ghostx
Junior Member

12-23-2016, 10:32 AM

Remove the processor, wait a few seconds, then reinsert it. Set the RAM to the second slot.

xKing_Ghostx

12-23-2016, 10:32 AM #5

Remove the processor, wait a few seconds, then reinsert it. Set the RAM to the second slot.

Boba999
Member

130

01-07-2017, 01:59 PM

Could you confirm whether the problem has been fixed? I'm also experiencing the same issue and have tried all the solutions provided, but nothing worked.

Boba999

01-07-2017, 01:59 PM #6

Could you confirm whether the problem has been fixed? I'm also experiencing the same issue and have tried all the solutions provided, but nothing worked.