F5F Stay Refreshed Hardware Desktop No, CL/Latency doesn't influence compatibility.

No, CL/Latency doesn't influence compatibility.

No, CL/Latency doesn't influence compatibility.

Pages (2): Previous 1 2
B
Bartercardinal
Member
Find
169
06-15-2023, 04:07 PM
#11
I'm experiencing the same issue myself. I only remove one side of the rams to avoid detection, but it still gets stuck at a certain code. This time I think the problem is related to the postcode I'm using—it seems it's expecting a signal that isn't present. I managed to push them in slightly more, but the rams didn't fully engage and now I have these confusing photos. I'm really curious about what would happen if I overclock them given the sensitivity of RAM to timing. If I figure it out, I'll definitely enjoy experimenting with it!
Reply
Reply
B
Bartercardinal
06-15-2023, 04:07 PM #11

I'm experiencing the same issue myself. I only remove one side of the rams to avoid detection, but it still gets stuck at a certain code. This time I think the problem is related to the postcode I'm using—it seems it's expecting a signal that isn't present. I managed to push them in slightly more, but the rams didn't fully engage and now I have these confusing photos. I'm really curious about what would happen if I overclock them given the sensitivity of RAM to timing. If I figure it out, I'll definitely enjoy experimenting with it!

Reply
Reply
I
ironman2255
Member
Find
133
06-15-2023, 04:47 PM
#12
The picture isn't that bad, the RAM pins aren't visible which suggests they're probably in contact at least 70-80% of the time
Reply
Reply
I
ironman2255
06-15-2023, 04:47 PM #12

The picture isn't that bad, the RAM pins aren't visible which suggests they're probably in contact at least 70-80% of the time

Reply
Reply
K
KizuPvP
Member
Find
137
06-15-2023, 06:26 PM
#13
It's really obvious it's that gray object at the bottom of the rams. You can see it getting close to the left side of the photo. Maybe I should have shot from another angle. Still, picture this: a 3000+ DDR3 setup with something like that.
Reply
Reply
K
KizuPvP
06-15-2023, 06:26 PM #13

It's really obvious it's that gray object at the bottom of the rams. You can see it getting close to the left side of the photo. Maybe I should have shot from another angle. Still, picture this: a 3000+ DDR3 setup with something like that.

Reply
Reply
Pages (2): Previous 1 2