No, a 1GB router likely won't support 32 security cameras simultaneously due to bandwidth limitations.
No, a 1GB router likely won't support 32 security cameras simultaneously due to bandwidth limitations.
You're facing common challenges with expanding your camera network. The router you're using may not handle the increased load efficiently, especially with high-resolution cameras. Consider upgrading to a router that supports more simultaneous connections and offers better performance for video streaming. Look for models with dedicated GPUs or solid-state drives for faster processing. If budget allows, investing in a higher-end router will ensure smoother operation and future-proof your setup.
This refers to a 1GB file size, likely related to storage or data usage. To confirm if your lag or freezing is caused by your router, check for network stability, update router firmware, and test connectivity.
All IP cameras link via a router. If yours connect straight to the NVR, it’s likely your NVR includes a built-in router and switch—most don’t, and they often perform poorly.
They likely link to a switch and unless they're using the Internet, the data won't reach the router—it flows straight between the camera and NVR, or between the camera and the viewer you're streaming from. Even though a switch connects to a router, not every connection goes through it. This is why switches are designed to send traffic directly to the correct port for the request. Only data destined for an IP outside your local network or the router itself travels to the router (often your default gateway), where it determines the best path to its final destination. Usually this involves multiple routers until it arrives at the correct next hop, which continues until it reaches its target.
Unless your switch has 32 ports, you're probably routing through the switches. As mentioned earlier, switches forward traffic straight to the intended MAC address, and unless the only path to reach that address is through the router, the data won't actually pass through it. That said, if you're pushing too many devices onto a switch (just a naming quirk here), it could cause problems. In theory, it should work, but network layout matters. How is your setup looking?
I just verified the router has only 100Mbit ports, meaning you should connect one switch directly to the router and any additional switches to that single switch. While chaining switches isn't harmful, it can create bottlenecks; having a dedicated main switch helps avoid this. At minimum, ensure the NVR and cameras are on the same switch for a direct, unobstructed connection back to the NVR without overloading the LAN between switches.