New Ram Card Oc Help

Ted_Lemons
Junior Member

10-06-2019, 10:35 PM

Hello everyone
I just purchased a new Memory card
Kingston FURY Renegade DDR4 Memory 2x16 3600 mhz
https://pasteboard.co/EDS6tyyHc8kW.jpg
https://pasteboard.co/iI69fURqoV2m.jpg
I followed these steps: I entered BIOS and opened the profile, set the frequency to 3600mhz, added a DRAM voltage of up to 1.35V. After a few boot cycles the system defaulted back to the default settings. Then I adjusted the frequency to 3500 and kept the voltage at 1.35V. The PC started working normally and no errors appeared during the memory check for three hours.
Any reason I couldn’t reach 3600mhz? Thanks a lot.

Ted_Lemons

10-06-2019, 10:35 PM #1

iSenpaiKitty
Member

197

10-07-2019, 05:42 AM

Restore to the default setting and then activate XMP.

iSenpaiKitty

10-07-2019, 05:42 AM #2

Restore to the default setting and then activate XMP.

NJG8
Member

10-12-2019, 07:49 PM

Hey .. let me know how you're doing
I tried it but my PC won't let me boot at 3600 MHz
Then I switched to 3500 MHz and it worked fine
I'm curious about why I keep getting a boot loop when using the 100 MHz boost
My new card is supposed to be 3600 MHz according to the specs

NJG8

10-12-2019, 07:49 PM #3

Texas1047
Posting Freak

889

10-19-2019, 09:58 PM

It might be the CPU memory controller or the memory itself. 3600 is an overclock setting and may not function properly without further tweaks.

Texas1047

10-19-2019, 09:58 PM #4

It might be the CPU memory controller or the memory itself. 3600 is an overclock setting and may not function properly without further tweaks.

Frankette44
Posting Freak

809

10-27-2019, 04:58 PM

Sure, I can ask what adjustments are required.

Frankette44

10-27-2019, 04:58 PM #5

Sure, I can ask what adjustments are required.

Ha12Nn6aH3
Member

138

10-27-2019, 05:56 PM

Just like the previous steps that stabilized at 3500, you could attempt raising the voltage by 0.02 or adjusting the timing parameters.

Ha12Nn6aH3

10-27-2019, 05:56 PM #6

Just like the previous steps that stabilized at 3500, you could attempt raising the voltage by 0.02 or adjusting the timing parameters.

X_Impossible_X
Member

226

10-29-2019, 02:03 AM

I increased it to 1.4v but got the same outcome, unfortunately. I'm not sure where I made the mistake.

X_Impossible_X

10-29-2019, 02:03 AM #7

I increased it to 1.4v but got the same outcome, unfortunately. I'm not sure where I made the mistake.