Network setup for your home devices
Network setup for your home devices
I'm sorry for any confusion. If you own a 24-port switch, you can connect your modem directly to one of the ports. You don't need a router or additional setup unless you're using a specific network configuration. The back port on Eero Mesh Network Base might be useful in certain advanced scenarios, but it's not necessary for basic connectivity.
So most homeowners encounter a modem/router package. This set includes a router, a modem, and a switch. It delivers Wi-Fi and lets you connect Ethernet devices. The modem simply translates the ISP signal so your devices can interpret it. Ideally you want three components: - Modem - Router - Switch The modem converts the ISP signal which goes into the router. The router assigns IP addresses and manages internet traffic, but doesn’t provide Wi-Fi unless it has one. Some routers come with built-in switches, typically offering four ports for connecting devices. The switch connects to the router and adds more ports for additional use. Also, an access point supplies Wi-Fi coverage. If you only need Ethernet, an access point isn’t necessary. -- My setup, for example, uses my Motorola modem for decoding, then the router handles routing and acts as a switch and access point.
Ensure your Eero Mesh Network base functions as a router. Connect the switch to it, then link the Mesh base to the modem. For setup, consider using two routers—one for home traffic and another for customer PCs. Both should connect via the modem (providing at least two ports). Alternatively, implement a VLAN solution if needed.
Yes, you're correct. You'll need a separate router to act as a bridge between your modem and the switch, just like a power strip connects an outlet to a device. If your Eero system functions as a router, you can connect its Ethernet port to the switch, allowing it to manage network traffic effectively.
Search for a four-port switch and link it to your modem. Then connect two routers from that switch. It’s best to use routers with sufficient ports for customer PCs. Alternatively, you could run a direct wire from the modem switch to Room 1, place a router there, and keep the other router at home connected to the main switch. This setup allows easy disconnection when not needed. For the home side, connect the 24-port switch to the home router and configure the rest as desired. I recommend two routers for better value, though I’m not familiar with VLAN settings.
You can reach out for any future inquiries—just message me or post on the forum!