Network assistance for mesh or other connections
Network assistance for mesh or other connections
You're facing some common issues with your current setup. Let's break it down:
1. **XFi Gateway & WiFi Speed** – You're getting terrible WiFi speeds, even though you have a 250Mbps plan. This could be due to interference from other devices, poor placement of the router, or outdated firmware. Check for overlapping networks and consider updating your router's settings.
2. **TCL TV Performance** – Your TV only manages 25-30Mbps on WiFi, while it handles 70Mbps over Ethernet. This suggests a significant bandwidth mismatch. Try switching to a wired connection for the TV or upgrading your network speed if possible.
3. **Linksys Velop Mesh Network** – Low download speeds in the mesh network are likely caused by weak signal strength, interference, or insufficient mesh nodes. Ensure all mesh devices are properly placed and consider adding more nodes for better coverage.
4. **Ethernet Cables for Full Coverage** – Since you can't install cables everywhere, focus on optimizing your existing setup: use a quality Ethernet switch, position it centrally, and ensure minimal interference from walls or appliances. If possible, upgrade to a higher-speed cable (e.g., Cat6a) for better performance.
Let me know if you'd like more detailed steps for any of these!
This decision involves weighing advantages and disadvantages. Upgrading to a dedicated router or a full Ubiquiti setup can offer better control, security, and performance. However, it may require more investment in hardware and configuration. A rack build gives flexibility but demands technical expertise. Consider your budget, network size, and long-term goals before choosing.
Connect the XFi gateway to your Velop setup. Disable Wi-Fi, turn off DHCP, disable firewall settings, and treat the device solely as a modem. Verify your Velop system is properly configured for N/AC or AC-only operation with channel width set at 80 or 160MHz. Check if your Velop overlaps neighboring Wi-Fi channels. If you connect via a computer and run a speed test, are you achieving the full internet speed?
The main point is you're being charged for something you shouldn't be paying for. If the speeds aren't working through the line, it's likely a service problem. You should contact them directly and be firm. Alternatively, you can purchase your own modem to avoid ongoing monthly fees. They provide a selection of compatible models.
I’m getting the full performance from my computer setup. It seems the TV might be the problem, but I wasn’t sure. I haven’t adjusted the bridging settings and don’t know whether it’s N/AC or just AC. I also haven’t looked into channel overlap yet. I’ll move in a few days to a new place and wanted to verify these points beforehand. How can I check them? I understand there’s a channel feature in the app to see available channels. I’m unsure about the other steps. Additionally, is it possible to run Ethernet cables discreetly inside the apartment without leaving them everywhere? Thanks for your help.