Need assistance with Prime95? Let me know what you're trying to achieve!
Need assistance with Prime95? Let me know what you're trying to achieve!
Sure, you can try different stability testing modes in Prime95. Start with the "Stress" or "Maximum" mode for maximum load, and compare results. If you want a more balanced approach, use "Load Test" or "Performance" settings. This will help you assess your system's reliability.
You should verify the memory issue first, as it’s more probable than the CPU. For CPU testing, run minimal FFTs and observe performance over time based on your BSOD frequency.
Start with MEMS using MemTest86 on the official x86 memory testing site, followed by small CPU FFTs. Run at least one full pass; if two passes show no errors, the MEMS is likely safe, though you can run additional passes for extra confidence. Minimum 15 minutes of FFTs is recommended, preferably longer. Monitor temperatures while checking P95 to avoid overheating.
This result is unusual. Is it typical for a CPU to reach such high temperatures in just one minute during testing?
That's not ideal. A price under $90 would work. But if it doesn’t fail, the CPU should remain stable.
From what I observe, the temperature is quite high. It appears to be an older CPU, and I don’t recall any processors reaching such a high operating temperature back then. Some sources mention 90° could harm the CPU, while others disagree. The only information I found from Intel states the maximum IHS temperature is around 60°. I suggest you take measures to lower the temperatures and monitor it closely until you reach a stable condition.