Mixing rams without compromising performance?
Mixing rams without compromising performance?
I own three sticks of RAM which is
Teamgroup T-force 3200 cl16 8x8x8
I only set up 16GB for dual channel, I didn’t install the third one because I don’t want any drop in performance. I’m thinking about purchasing another 8GB to reach a total of 32GB, but I’m having trouble finding a single one and can’t buy it on Amazon due to issues.
The question is, can I buy a different model? Would an 8GB RAM from a different brand be okay? Would that affect performance? Thank you all in advance, and what suggestions do you have?
Spec:
CPU i7 9700k
Windows 11
Rtx 2060
Power supply cougar xtc 500w
Ram 16GB 8x8 teamgroup t force
It's generally not advisable as it may lead to stability and performance problems. Have I already tried it? Yes. It could have functioned well, failed completely, or seemed fine until it crashed under stress. Essentially, it can be a frustrating experience. The best solution is to purchase a compatible kit if available. However, if you find an extra stick or someone offers one, it's worth testing, though results may vary and issues could still arise. The chances of success are roughly equal.
Ram is sold this way for a specific purpose.
A motherboard needs to handle all the RAM according to the same voltage, case, and speed requirements.
The internal design is tailored to the kit’s capacity.
Ram from the same manufacturer and part number may vary in manufacturing over time.
Certain motherboards are quite sensitive to these changes.
This becomes more challenging when multiple sticks are used.
It’s essential to match the RAM for optimal performance.
Sometimes you can adjust for issues by raising the RAM voltage on the motherboard BIOS, provided your board supports this.
Older Intel processors generally handle mixed RAM well.
With the additional stick available, feel free to experiment.
Check performance before and after running your usual tasks.
The matched 16GB will operate in dual-channel mode, while the single stick will run in single-channel mode—this is known as flex mode.
To the degree your applications can effectively use 24GB, you’ll likely perform better.
You probably won’t notice any significant difference.
Set up the additional RAM module in the correct port.
Ensure the monitor displays the full amount of RAM at the right rate.
Test your applications to check for differences.
If needed, this should reduce your reliance on the swap file somewhat.
That's the issue, for instance I was considering getting two RAM sticks similar to the one I own, which is TeamGroup 8x8, and possibly I could obtain an 8x8 HyperX model and set it up.
Only it is assured when sold in a package and in the identical box.
You're aiming to invest funds for a trial scenario.
It might succeed, might not, but it could be effective.
Consider reselling or reusing what you possess, acquiring only what's necessary.
Thanks a lot for your information. It really helps. I tried installing 16GB of RAM on my old PC, but they’re different models—one was a Viper and another was TeamGroup. They worked fine, though. In terms of performance, I’m not sure if there were any noticeable differences, but someone suggested removing the RAM and putting it back to check. I’m not sure if that affected anything.
Thanks a lot for your information. It really helps. I tried installing 16GB of RAM on my old PC, but they’re different models—one was a Viper and the other was TeamGroup. They worked fine in terms of speed. I’m not sure if there was any performance difference, but I think I need to remove the RAM and put it back again. In terms of performance, I’m still unsure. Thank you so much for your help!