mixing ram
mixing ram
Hello, you're looking to combine your existing RAM with a new upgrade. Based on your setup, it's possible if you follow the right configuration. Your old 2GB DDR3 1600MHz RAM works fine, and your new 4GB DDR3 1600MHz RAM should also fit. Since both are DDR3 1600MHz, mixing them is feasible. You'll need to ensure both are installed in the same slot with single-channel mode enabled. Your system has two slots, so you can proceed safely. Just double-check compatibility and power settings before booting.
Yes, on paper the memory gets combined and it functions. The advice was to keep the same type of RAM as before for smooth performance. The main concern was speed limitations, not total failure. Regarding the swap, I’m not sure if you replaced 4GB with 2GB or did something else.
Hello, I was planning to upgrade my system's RAM to 4GB, but the new module didn't work. After replacing it with the old 2GB module (1RX8 PC3-12800U-11-13-A1), the system started up. Now I'm curious if mixing different RAM modules is possible. My previous 2GB RAM was a 1RAM-8bit version, and my new one is a 4GB 1RAM-8bit model.
It's important to verify if the motherboard matches the new one. The process should be feasible with compatible models. Similar model numbers increase the likelihood of success. On functioning systems, avoid any damage. (Note: The RAM sticks shown are on both sides, not just top and bottom.)