Minor twist in the mainboard.

lulugdb
Member

174

06-16-2016, 08:39 AM

Hello, I've been assembling my initial PC and after fitting the motherboard I've observed minor warping near the socket area. I've taken great care, double-checked the standoffs and the space behind the motherboard before each installation five times. Now that the board is out of the case it still isn't perfectly straight. I'm trying to decide: 1) it functions and I should return it for replacement, 2) it won't work, or 3) it does work and I'll keep it. My main concern is whether I should send it back or if these small issues are typical during production and I should just overlook them.

lulugdb

06-16-2016, 08:39 AM #1

qFame
Member

197

06-17-2016, 01:27 PM

In the second shot, is it really just the right edge that stands out above the rest? Could aligning the mobile neatly against the table surface—edge touching the top—change the outcome?

qFame

06-17-2016, 01:27 PM #2

In the second shot, is it really just the right edge that stands out above the rest? Could aligning the mobile neatly against the table surface—edge touching the top—change the outcome?

Brett558
Junior Member

06-28-2016, 11:54 PM

Based on my limited experience, it seems the VRM heat sink could be contributing to the board bending, especially since it's likely attached to the ends. If you're worried, reaching out to the manufacturer with photos might give you clearer guidance.

Brett558

06-28-2016, 11:54 PM #3

tapper324
Junior Member

07-20-2016, 06:43 PM

Many boards are slightly bent. This appears to be a lower-cost version, with tighter tolerance requirements.

tapper324

07-20-2016, 06:43 PM #4

Many boards are slightly bent. This appears to be a lower-cost version, with tighter tolerance requirements.

JULIANO030
Member

226

07-20-2016, 07:24 PM

Missed adding the ASUS TUF GAMING X670E-PLUS to the list. I’ll also try taking the photo on A4 paper flat against the table—backplate was an issue before. The heat sink seems secured with screws across the bend; should I loosen them? Also, would upgrading the motherboard be a better idea for the future?