Looking for assistance with adjusting the volume on Phenom II 955?
Looking for assistance with adjusting the volume on Phenom II 955?
Thank you for the data! I've been exploring undervolting techniques but haven't made any changes to adjust my voltages.
Thanks for the data! I've been exploring undervolting and haven't yet adjusted my voltages to their optimal levels.
All the best!
I achieved solid outcomes with a linear method—adjusting frequency based on voltage changes. By setting the two ends (3200 and 800 MHz), you can calculate the intermediate voltages (for 2400 and 1600 MHz in my case).
This undervolting result isn't the worst I've encountered, though it's not ideal or top-notch. It seems to be a bit of an overclock rather than a focused undervolt test. However, it performed adequately at lower voltages compared to other 550 models that need around 4 ghz just for basic operation. The same processor reached 6.7 ghz even with LN2 cooling.
That's not too bad for undervolting. It isn't the ideal or top choice, but it's a bit above average. This is the highest undervolting I've encountered. Although it's more of an overclock rather than a focused undervolt test, it was performing well under the voltage most other 550s need for just a 4 ghz clock. The same processor reached 6.7 ghz on LN2.
Nice link! These are unreleased and carefully chosen C3 chips, which should outperform any standard C2 chip available in stores. I'm sure they were selected, even though AMD might try to deny it. I've already reached out to AMD to find out if they'll be released and when.