F5F Stay Refreshed Hardware Desktop Issue identified: PC fails to upload with 5800x added.

Issue identified: PC fails to upload with 5800x added.

Issue identified: PC fails to upload with 5800x added.

I
ImCarter_
Junior Member
1
01-19-2020, 06:17 PM
#1
Checked warranty and found a bent pin caused the post to fail. This is likely an AMD issue. I followed these steps: downloaded the latest BIOS updates for my Aorus X570 Pro WiFi, installed them on a flash drive, updated to f32, and rebooted. The BIOS now shows f32. I swapped in my 3700X and everything worked perfectly. After a CMOS reset, the light flashed once when I powered it back up, but it only appeared after turning on after the reset. The 5800X still didn’t boot properly. I’m wondering if there’s a missing step or compatibility issue with the new BIOS version. I’ll stick with the 3700X for now but hope to upgrade eventually. Updated June 25, 2021 by Mopshond
I
ImCarter_
01-19-2020, 06:17 PM #1

Checked warranty and found a bent pin caused the post to fail. This is likely an AMD issue. I followed these steps: downloaded the latest BIOS updates for my Aorus X570 Pro WiFi, installed them on a flash drive, updated to f32, and rebooted. The BIOS now shows f32. I swapped in my 3700X and everything worked perfectly. After a CMOS reset, the light flashed once when I powered it back up, but it only appeared after turning on after the reset. The 5800X still didn’t boot properly. I’m wondering if there’s a missing step or compatibility issue with the new BIOS version. I’ll stick with the 3700X for now but hope to upgrade eventually. Updated June 25, 2021 by Mopshond

S
skilzoidknight
Junior Member
5
01-21-2020, 12:28 AM
#2
I haven’t come across a hardware setup where the 5800 stops working while the 3700 remains functional. That doesn’t rule it out entirely. Would you like me to process an RMA for the CPU? I’m assuming there’s a valid reason preventing it from being handled.
S
skilzoidknight
01-21-2020, 12:28 AM #2

I haven’t come across a hardware setup where the 5800 stops working while the 3700 remains functional. That doesn’t rule it out entirely. Would you like me to process an RMA for the CPU? I’m assuming there’s a valid reason preventing it from being handled.

F
ForeverAthena
Member
215
01-22-2020, 05:47 AM
#3
I think I’ll just return it under warranty and check if they believe it’s faulty. I’m not able to test it on another machine, so I can’t confirm further. Everything looks normal based on what I’ve seen so far. Right now, it’s running well with the 3700x and doesn’t move much with the 5800x. It seems like a typical issue.
F
ForeverAthena
01-22-2020, 05:47 AM #3

I think I’ll just return it under warranty and check if they believe it’s faulty. I’m not able to test it on another machine, so I can’t confirm further. Everything looks normal based on what I’ve seen so far. Right now, it’s running well with the 3700x and doesn’t move much with the 5800x. It seems like a typical issue.

B
BangerLps
Junior Member
12
01-22-2020, 07:22 AM
#4
Hello.. Remove all Sata and USB drives. Disconnect the power supply. Install the Ryzen 5000. Wipe CMOS (or simply discharge the CMOS battery for 5 minutes). Re-flash F32 once the board is ready. If that fails, try flashing F30 before proceeding with F32.
B
BangerLps
01-22-2020, 07:22 AM #4

Hello.. Remove all Sata and USB drives. Disconnect the power supply. Install the Ryzen 5000. Wipe CMOS (or simply discharge the CMOS battery for 5 minutes). Re-flash F32 once the board is ready. If that fails, try flashing F30 before proceeding with F32.

X
Xrimir
Junior Member
9
01-23-2020, 05:10 AM
#5
You're considering different setups for your system. It seems you have both a SATA SSD and an M.2 SSD. You're wondering if disconnecting just the SATA drive or both would work, and whether you should clear CMOS again. You mentioned seeing a faint light after powering on once, which might indicate a reset. You're planning to reinstall F32 and are aware that the BIOS won't boot with the 5800X chipset. Removing the SATA drive might be a better approach to test the BIOS functionality.
X
Xrimir
01-23-2020, 05:10 AM #5

You're considering different setups for your system. It seems you have both a SATA SSD and an M.2 SSD. You're wondering if disconnecting just the SATA drive or both would work, and whether you should clear CMOS again. You mentioned seeing a faint light after powering on once, which might indicate a reset. You're planning to reinstall F32 and are aware that the BIOS won't boot with the 5800X chipset. Removing the SATA drive might be a better approach to test the BIOS functionality.

L
LU_KAS
Member
147
01-28-2020, 11:34 PM
#6
Just disconnect the SATA and USB connections. The board can be flashed without a CPU, making it suitable for the 5800x model.
L
LU_KAS
01-28-2020, 11:34 PM #6

Just disconnect the SATA and USB connections. The board can be flashed without a CPU, making it suitable for the 5800x model.