F5F Stay Refreshed Hardware Desktop Is there a way to post without a CPU cooler?

Is there a way to post without a CPU cooler?

Is there a way to post without a CPU cooler?

P
PMX305
Member
183
09-14-2021, 03:33 AM
#1
You're looking to see if any main parts fail during boot without using a CPU cooler, saving money by avoiding a $10 purchase. It's possible to test this by running the system and checking for crashes or errors. You can also try booting with minimal components to isolate the issue.
P
PMX305
09-14-2021, 03:33 AM #1

You're looking to see if any main parts fail during boot without using a CPU cooler, saving money by avoiding a $10 purchase. It's possible to test this by running the system and checking for crashes or errors. You can also try booting with minimal components to isolate the issue.

L
Lindinger
Member
208
10-04-2021, 04:27 AM
#2
Sure thing. Let me know if you need anything adjusted.
L
Lindinger
10-04-2021, 04:27 AM #2

Sure thing. Let me know if you need anything adjusted.

L
lalaloopsy89
Junior Member
47
10-11-2021, 02:15 AM
#3
You can start from the desktop, tap the CPU, or use a laser temp gun. Shut it down when it lands on the desktop at startup.
L
lalaloopsy89
10-11-2021, 02:15 AM #3

You can start from the desktop, tap the CPU, or use a laser temp gun. Shut it down when it lands on the desktop at startup.

S
shacklebolt323
Member
218
10-11-2021, 02:24 PM
#4
Yes, approximately three minutes is acceptable. You shouldn't go beyond about 60 seconds...
S
shacklebolt323
10-11-2021, 02:24 PM #4

Yes, approximately three minutes is acceptable. You shouldn't go beyond about 60 seconds...

A
Anselhero
Senior Member
582
10-11-2021, 06:53 PM
#5
Open BIOS via POST/get and keep it idle; power off is acceptable. Launch the desktop boot sequence, which will take a while, but don’t worry. I experienced this with my 5960X during a rebuild—when I entered BIOS, it was extremely hot (>60°C) within ten seconds.
A
Anselhero
10-11-2021, 06:53 PM #5

Open BIOS via POST/get and keep it idle; power off is acceptable. Launch the desktop boot sequence, which will take a while, but don’t worry. I experienced this with my 5960X during a rebuild—when I entered BIOS, it was extremely hot (>60°C) within ten seconds.

I
isaac_videos
Member
128
10-12-2021, 02:18 AM
#6
Carry a waterblock and place it on the CPU—it should work fine. If you don’t have one, a bare CPU might stop functioning after about three minutes. After that, just use the BIOS, which can run for up to thirty seconds.
I
isaac_videos
10-12-2021, 02:18 AM #6

Carry a waterblock and place it on the CPU—it should work fine. If you don’t have one, a bare CPU might stop functioning after about three minutes. After that, just use the BIOS, which can run for up to thirty seconds.

C
CandyBugz
Member
122
10-17-2021, 02:34 PM
#7
Great! Let's get started.
C
CandyBugz
10-17-2021, 02:34 PM #7

Great! Let's get started.

A
adesignarPT
Member
87
10-18-2021, 03:46 PM
#8
45c+ becomes increasingly risky to handle
A
adesignarPT
10-18-2021, 03:46 PM #8

45c+ becomes increasingly risky to handle

L
lillboman91
Member
164
10-24-2021, 08:26 PM
#9
The system will power itself off to avoid further harm. Avoid turning it back on immediately if it does so. Allow it to settle down. A short post-test is acceptable—no need for a temperature gun, and don’t handle it with your fingers (unless you’re curious about testing the stove’s temp with your own hand).
L
lillboman91
10-24-2021, 08:26 PM #9

The system will power itself off to avoid further harm. Avoid turning it back on immediately if it does so. Allow it to settle down. A short post-test is acceptable—no need for a temperature gun, and don’t handle it with your fingers (unless you’re curious about testing the stove’s temp with your own hand).

O
OverlordCoby
Member
169
10-24-2021, 09:25 PM
#10
Use an air can and invert it to help lower the CPU temperature.
O
OverlordCoby
10-24-2021, 09:25 PM #10

Use an air can and invert it to help lower the CPU temperature.