F5F Stay Refreshed Hardware Desktop Is my 5600X overheating?

Is my 5600X overheating?

Is my 5600X overheating?

R
reaganroo
Junior Member
10
08-21-2020, 01:45 AM
#1
Your 5600X is heating up a bit, especially after a short gaming session. At around 82°C it seems a bit high, though not extreme. You're using the Deepcool LS 520 SE and haven't had any issues so far. Testing Cinebench showed 76, but your PC is still warming up as you power it on. It might just be a bit more conscious than usual.
R
reaganroo
08-21-2020, 01:45 AM #1

Your 5600X is heating up a bit, especially after a short gaming session. At around 82°C it seems a bit high, though not extreme. You're using the Deepcool LS 520 SE and haven't had any issues so far. Testing Cinebench showed 76, but your PC is still warming up as you power it on. It might just be a bit more conscious than usual.

B
Baby_Nae
Member
63
08-24-2020, 05:26 AM
#2
Your CPU is operating normally and the 82C temperature is safely below thresholds. Consider adjusting the AIO pump speed in BIOS to slightly reduce heat without boosting fans or noise. No action required—everything appears fine.
B
Baby_Nae
08-24-2020, 05:26 AM #2

Your CPU is operating normally and the 82C temperature is safely below thresholds. Consider adjusting the AIO pump speed in BIOS to slightly reduce heat without boosting fans or noise. No action required—everything appears fine.

S
Silvinha10
Senior Member
694
08-26-2020, 06:57 AM
#3
You're considering upgrading your thermal paste for the AIO. For recommendations, look into high-quality brands like Thermal Paste Plus or Cooler Master. Avoid generic or low-grade products that may not perform well under heat. Always check reviews specific to your cooling setup.
S
Silvinha10
08-26-2020, 06:57 AM #3

You're considering upgrading your thermal paste for the AIO. For recommendations, look into high-quality brands like Thermal Paste Plus or Cooler Master. Avoid generic or low-grade products that may not perform well under heat. Always check reviews specific to your cooling setup.

C
CatsGoMeow123
Member
158
08-26-2020, 07:22 AM
#4
It's unlikely to notice a major change in temperature with the DeepCool thermal paste. You might see only a slight improvement, perhaps a couple of degrees at most. As noted, boost the pump speed if it's running low in the BIOS settings.
C
CatsGoMeow123
08-26-2020, 07:22 AM #4

It's unlikely to notice a major change in temperature with the DeepCool thermal paste. You might see only a slight improvement, perhaps a couple of degrees at most. As noted, boost the pump speed if it's running low in the BIOS settings.

N
179
09-13-2020, 08:44 PM
#5
I just adjusted the pump speed to its maximum setting, and I plan to perform a stress test.
N
NicknameNumber
09-13-2020, 08:44 PM #5

I just adjusted the pump speed to its maximum setting, and I plan to perform a stress test.

B
BattleHack
Member
156
10-01-2020, 09:44 AM
#6
Great idea! I suggest keeping the pump speed steady around 70-75%. It works well enough to move a lot of fluid without making it too loud, and maintaining a constant speed helps the pump last longer. It’s also better for the pump’s health than frequent changes. The temperature is fine at 82°C—just not too hot.
B
BattleHack
10-01-2020, 09:44 AM #6

Great idea! I suggest keeping the pump speed steady around 70-75%. It works well enough to move a lot of fluid without making it too loud, and maintaining a constant speed helps the pump last longer. It’s also better for the pump’s health than frequent changes. The temperature is fine at 82°C—just not too hot.

S
spidersaur187
Member
201
10-01-2020, 11:19 AM
#7
The pump speed setting is no longer visible in the BIOS. It was accessible via favorites previously. For your Gigabyte Aorus B550 Elite AX V2, you can check the device manager or the motherboard manual for the correct location.
S
spidersaur187
10-01-2020, 11:19 AM #7

The pump speed setting is no longer visible in the BIOS. It was accessible via favorites previously. For your Gigabyte Aorus B550 Elite AX V2, you can check the device manager or the motherboard manual for the correct location.

A
AngelmeisterJ
Member
52
10-15-2020, 07:44 PM
#8
In the BIOS, look for Smart Fan 5 or use the F6 key on your keyboard. This should resolve the issue.
A
AngelmeisterJ
10-15-2020, 07:44 PM #8

In the BIOS, look for Smart Fan 5 or use the F6 key on your keyboard. This should resolve the issue.