Is it alright if your GPU is secured with just a single screw?
Is it alright if your GPU is secured with just a single screw?
My pc case's screw holes for the gpu have enlargened a bit. I now use the screw used to hold my case's glass becasue the small screws won't fit. Now my gpu is only held by one thumbscrew. my gpu has two holes and under the last hole I fastened the small screw on the my case's third gpu holding screw hole so that if the thumbscrew get's loose my gpu won't really fall off? It's been a couple of days and it's seems fine but I'm worried about the bad day. GPU: RX 590 GME
Welcome to the forums, newcomer! I'm curious if the case you're using is made from cheap materials, possibly with weak metal. The screws seem to have worn out the internal threading of the PCIe slots. It might be helpful to include a picture showing how the GPU is mounted to the chassis. As long as the GPU stays in place when moving the case, it should be okay—but if you're concerned, keep an eye on it just in case your desk shifts and damages the PCIe slot on the motherboard. Alternatively, consider getting a new case with the right screws. It's been a few days so far, but I'm still worried about something going wrong. If you have funds available, you can ignore the questionable approach.
Welcome to the forums, newcomer! I’m curious if the case you’re using looks cheap, possibly made from weak metal? The screws seem to have worn out the internal threading of the PCIe slots. It might help to include a picture showing how the GPU is mounted to the chassis. As long as the GPU stays in place when moving the case, it should be okay—but if you were worried, keep an eye on it just in case your desk shifts and damages the PCIe slot on the motherboard. Alternatively, consider getting a new case with the right screws. It’s been a few days so far, but I’m still concerned about something going wrong. If you have funds available, you can ignore the questionable GPU mounting. But if not, protect your investment by choosing a better case.
On the opposite side of the second screw, place a nut. You might also use a zip tie for a more inventive solution. I've handled similar adjustments in the past.