Initial overclocking experience with 3770k - assistance needed
Initial overclocking experience with 3770k - assistance needed
I purchased a PC in 2012 from CyberpowerPC, equipped with a 3770k on an ASUS P8Z77-V LK motherboard that came with a liquid cooling kit. I didn’t expect it to be overclocked, but here are the results I’m seeing on Prime95: maximum 81 degrees during the 8k test, reaching 85 after about 20 minutes. It’s clearly not the stock speed, around 22-23% over the base. I’m planning to attempt a self-overclock before upgrading to a new build with a 6600k later this year. Any advice? I have CPUID, Prime95, Coretemp, and AIDA64 installed. The BIOS is decent but not outstanding. No specific targets, just want to experiment and see what happens.
These temperatures are quite high! - make sure you're not running a version of prime that leads to overheating.
If you experience these temps while gaming, it's best to lower the Vcore to 1.25V or even 1.2V to manage your temperatures.
75°C is a reasonable upper limit.
Reducing your voltage can cause occasional crashes, which may require lowering your speed to 4.2GHz.
Alternatively, you could opt for a more stable overclocker that performs well at lower voltages, potentially reaching 4.4Ghz at 1.2V without overheating.
(Higher Vcore leads to significantly more overheating than higher speed)
Another option is to upgrade your cooler, enabling you to run at 1.35V and boost your speed further. In my opinion...
These temperatures are quite high! - make sure you're not running a version of prime that leads to overheating.
If you notice these temps while gaming, it's best to lower the Vcore to 1.25V or even 1.2V to keep things stable.
75°C should be considered a safe upper limit.
Reducing your voltage might cause occasional crashes, which could push you to lower your speed to 4.2GHz.
Alternatively, you could invest in a better cooler, enabling you to run at 1.35V and boost your speed further.
Personally, I don't think it's worth the cost.
Heat in your CPU is essentially determined by Vcore multiplied by Vcore and speed.
Excessive heat can be harmful, but it's possible to address this issue with a more powerful cooler.
High Vcore reduces the lifespan of the processor.
In my setup, I opted for overclocking on a limited budget.
My budget motherboard only provides 3 phase VRM power, which means I have to keep Vcore below my CPU's maximum of 1.3V.
The existing cooler pushes me even further down to avoid overheating.
Despite this, I still managed to reach 4.2Ghz.