I9 9900k heat
I9 9900k heat
Hi guys, just checking if it's typical for an i9 9900k with the Asus xi hero to run Realbench with a 95C core under stock settings.
No, those temperatures are significantly too high at stock as they should be in the 70s with a custom loop. There seems to be an issue with your cooling system. The maximum temperature for the 9900k is 100°C, so you're almost there. Likely, you're reaching around 100°C and the CPU is downclocking to protect itself by lowering the temperature to 95°C.
No, those temperatures are significantly too high at stock as they should be in the 70s with a custom loop. There seems to be an issue with your cooling system. The maximum temperature for the 9900k is 100°C, so you're almost there. Likely, you're reaching around 100°C and the CPU is downclocking to protect itself by lowering the temperature to 95°C.
My loop order is pump, rtx2080ti, 240mm ek pe, cpu, 360 ek or then back to pump. This was running a real bench for 4 hours with 8gb mem. I have 16gb installed, and my gpu ran around 50-60 during this test.
I have my temperatures available if needed. I've adjusted the CPU block several times already. For the ECU block, it provides thumb screws and springs—tighten them until they reach their limits. Be careful not to overdo it, as this could cause issues.
I wouldn't go over tightening them too much, but I'd tighten until the end.
Are you sure you're applying thermal paste?
I'm employing the thermal grizzly Kryonaut with the spread technique.
k_closs :
I’m employing thermal grizzly Kryonaut with the spread method.
It’s possible you were told about the system type, but it’s hard to say for sure.
Could you confirm if the pumps are active? Are you certain it’s set to stock? You might want to reset the bios to factory defaults just to verify.
You don't have a flow meter, but the pipes close to the CPU are at roughly the same temperature as the rest.