I experienced an on-board component overheating and frying issue with my MSI KATANA GF66. Someone could assist?
I experienced an on-board component overheating and frying issue with my MSI KATANA GF66. Someone could assist?
I have an MSI GF66 Katana. While sleeping, the system likely failed, and I mistakenly thought it was my charger. After switching it in with a new charger, it made a clicking sound and began smoking. Upon checking the board, I found a fried component labeled PEC1—blackened but appears isolated. Since the board is discontinued, I’m seeking advice about this part. Could it be that the system died after the second charge attempt? Any information would be helpful. Thank you.
Welcome to the forums, newcomer!
I own an MSI GF66 Katana. Please note the SKU on your MSI laptop, which is on the bottom of the device on a sticker.
I’m seeking advice about the component—whether it’s a dead system after the second charge attempt or anything else. Any information would be helpful.
It seems replacing the faulty part should usually suffice. However, in more severe cases, you might need to fix damaged traces on the PCB. The worst scenario involves many steps, such as trying to pinpoint whether the problem lies with the blown component, MOSFET, capacitor, SMD, or a dead short. You may also consider voltage injection to check if any board section is overheating but not powering up.
It would be best to obtain a schematic diagram for your laptop’s motherboard. Here’s a relevant thread:
https://www.badcaps.net/forum/troub...ti...6-ms-15811
You might also consider visiting a local repair shop to see if they can handle all these tasks and get your laptop working again.
Moved the thread from the Motherboards section to the Laptop Tech Support section.