I don't see the RAM reaching 3200Mhz.
I don't see the RAM reaching 3200Mhz.
Ram: PVS416G320C6K (Hynix)
Mobo: H610M DDR4 REV 1.2
CPU: I3 12100F
GPU: Gtx 960
The issue is that I can't boot with XMP and have managed to start at 2800 MHz with 16, 20, 20, 40, 64 MHz manually after applying XMP on Easy Tune. However, it doesn't boot again after a restart. Any advice?
The latency settings 16-20-20-40 are the recommended values for the XMP 3200mhz profile. That's what the manufacturer has stated. These weren't randomly selected, you're right. Refer to the instructions in post #33 to determine the highest stable frequency your RAM can support.
Welcome to the forums, newcomer!
Ram: PVS416G320C6K (Hynix)
Is this the RAM kit you're using?
I managed to boot once at 3200 after applying XMP via Easy Tune.
Can't enable X.M.P in BIOS?
Mobo: H610M DDR4 REV 1.2
What BIOS version are you running for your motherboard?
I'm confirming this is my exact setup (though it isn't listed on QVL from H610M, it appears on QVL for my Mobo, so I assumed it would work). It functioned once at least.
I can turn on XMP in BIOS, but I won't boot until the CMOS is clean or until a warning prompts me to load the default settings.
F29 seems to be the latest model (I had the first version and F28 too, since F29 wasn't an official release at that time).
I tried Easy Tune + Real Memory Timing on Bios as a last resort—it worked once, without BSOD or instability. After exiting without saving, it didn't boot again.
Even though I can't solve this issue alone, it's the first time someone actually helped me out. Thank you!
You should choose the motherboard QVL instead of going with the RAM maker.
I understand, i just tought, oh my mobo it's on patriot QVL, it's fine right?, and, well, i had another Ram who actually wasn't on the motherboard QVL and it worked with xmp, but these two no.
In addition one time I could make the ram work on 3200 correctly, so i tought that would be possible to do it again.
It's possible to be fortunate, but RAM can be quite unpredictable.
Yeah, these past two months where a weekly try and don't figure out how to solve it. I know this couldn't not have other solution than buy other ram kit, but, it sucks, in my country these ram are 50$ usd, and there is no alternatives on 3200mhz on that price
the problem is i can't event go up to 2800, and, well i think you could realize that difference, for example, on mice latency, there is a noticeable difference between 2133 and 2600, and that one time i could go up to 3200 it's was like 1 step further on that theme.