I can assist you with that.
I can assist you with that.
If you proceed further in the BIOS menu, you'll find additional options accessible via the slide bar or by pressing the down arrow.
nothing else and various options spread spectrum and halt state thermal throttling. no excute memory and on demand clock modulation intel speed tech and btw i turned off all of this. the thing is, anything I change even a single fsb causes the guard failure boot to trigger and everything reverts to default again.
and one important thing is my RAM is bus 1333 and I already adjusted the setting on the board (follow the manual), but in cpuz it shows 500 MHz and in bios it reads DDR3 at 1000 MHz. If I try to change the DRAM frequency to 667 in bios, it boots up correctly, but I’m not sure what’s wrong. My goal is just to get 3.6 OC.